Filter
Top Products
4. The Sample Jobs
RS7000 247
5
The Sampling Mode
1 SAMPLE (Source Sample Number)...........[Knob 1]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the source sample voice.
2
KEY (Source Key Number)............................[Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the source sample.
3
SAMPLE
(Destination Sample Number) .....................[Knob 3]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the destination sample voice.
4
TYPE (Destination Type)................................[Knob 4]
[Settings] PITCHED, KIT: C-2 ~ G8
Specifies the type of the destination sample voice.
Selects the sample key number when the destination sample is a
Sample Kit Voice type.
5
AUDITION.......................................................................[F2]
Plays the specified move source sample.
6
DO!....................................................................................[F4]
Executes the job.
Maximizes (normalizes) the overall level of the specified sample.
1
SAMPLE (Sample Number)...........................[Knob 1]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be normalized.
2
KEY (Key Number) ........................................... [Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the sample to be normalized.
3
RATIO ..................................................................... [Knob 3]
[Settings] 001 ~ 800%
Specifies the post-normalization sample level.
A setting of 100% maximizes the level so that the highest
peak level in the sample is just below clipping (maximum
digital signal level).
Settings below 100% reduce the level of the sample accord-
ingly.
Settings higher than 100% will raise the sample level above
the maximum, producing deliberate clipping.
4
AUDITION...................................................................... [F2]
Plays the specified sample.
Plays the normalized sample if pressed after [F4] (DO!) is
pressed to normalize the sample.
5 DO!................................................................................... [F4]
Executes the job.
6
CREATE......................................................................... [F3]
Saves the processed sample to the target sample number,
overwriting the original sample.
If the original sample is a Pitched Sample it will be overwrit-
ten at this point. If the original sample is part of a Sample Kit
Voice a key-number selection page will appear.
7
CREATE TO
(Destination Key Number)............................ [Knob 2]
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
NOTE
• This parameter is not available when the
specified source sample is a Pitched Voice.
• When the last remaining sample is moved
from a Sample Kit Voice, the entire sample
voice is deleted.
NOTE
The PITCHED option is not available when a
Sample Kit Voice is stored in the destination
sample voice number.
05 NORMALIZE
35612
4
[Knob 1]
[Knob 2]
[Knob 3] [F4]
[F2]
[F3]
NOTE
This parameter is not available when the speci-
fied sample is a Pitched Voice.
Original
Waveform
100% Lower than 100% Higher than 100%
87
[Knob 2]
[F3]