Filter
Top Products
1. Sequential Pattern Playback (Pattern Chain Play)
RS7000 159
3
The Pattern Chain Mode
Pattern chains are created and played in this mode.
Press [PATT CHAIN] to go to the PATTERN CHAIN mode.
Pattern Chain Playback Procedure
1. Press [PATT CHAIN] to go to the PATTERN CHAIN Play
display.
2. Use [Knob 1] (CHAIN) to select the pattern chain to be
played.
3. Press the sequencer [PLAY] button to start chain playback.
Display Parameters
1 CHAIN............[Knob 1], [SHIFT]+[F1] → Numeric Keypad
2 Chain Name
[Settings]
Pattern Chain Number 01 ~ 20
Chain Name Display only.
Specifies the number of the pattern chain to be played.
3
STYLE............[Knob 2], [SHIFT]+[F2] → Numeric Keypad
4 SECTION ................................................... [F2] → [Knob 2]
1. Sequential Pattern Playback (Pattern Chain Play)
NOTE
Refer to “2. Pattern Chain Recording” on page 161 for details on recording pattern chains.
NOTE
• The parameters in the PATTERN CHAIN Play
display page can be edited during pattern
chain playback. Changes made during play-
back are temporary and will not overwrite the
pattern chain data. Refer to “2. Pattern Chain
Recording” on page 161 for details on record-
ing pattern chain changes.
• When you need to make large value changes
rotate a knob while holding the [SHIFT] button
to change values in increments of 10 rather
than 1.
• You can also use the SUB MODE buttons as
a numeric keypad to enter values after hold-
ing both the [SHIFT] and [F1] ~ [F4] button.
9
0
28
1673 4 5
[Knob 1]
[SHIFT]+[F1]
[Knob 2]
[F2]
[SHIFT]+[F2]
[Knob 3]
[SHIFT]+[F3]
[Knob 4]
[SHIFT]+[F4]