Filter
Top Products
4. The Sample Jobs
RS7000 251
5
The Sampling Mode
6 CREATE TO
(Destination Key Number).............................[Knob 2]
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
7
OK......................................................................................[F3]
Saves the processed sample to the specified destination key
number.
Converts a stereo sample to a mono sample.
1
SAMPLE (Sample Number)...........................[Knob 1]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be converted.
2
KEY (Key Number) ............................................[Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the sample to be converted.
3
TYPE.........................................................................[Knob 3]
[Settings] L+R>MONO, L>MONO, R>MONO
L+R>MONO......The left and right channels of the ste-
reo sample are mixed and converted
to a mono sample.
L>MONO...........The left channel on the stereo sample
is converted to a mono sample.
R>MONO..........The right channel on the stereo sam-
ple is converted to a mono sample.
Specifies which channel, or both channels, of the stereo sam-
ple will be converted to a mono sample.
4
AUDITION.......................................................................[F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to convert the sample.
5
DO!................................................................................... [F4]
Executes the job.
6
CREATE......................................................................... [F3]
Saves the processed sample to the target sample number,
overwriting the original sample.
If the original sample is a Pitched Sample it will be overwrit-
ten at this point. If the original sample is part of a Sample Kit
Voice a key-number selection page will appear.
7
CREATE TO
(Destination Key Number)............................ [Knob 2]
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
8
OK..................................................................................... [F3]
Saves the processed sample to the specified destination key
number.
Slices and randomly rearranges the selected sample while also
changing the sound of some portions to create totally new varia-
tions.
This job is effective when used with accurately-extracted 1 or 2-
measure break-beats or phrase samples. Before using the Loop
Remix job, set the loop start and end points in the Trim page, and
then use the sample Extract job.
1
SAMPLE (Sample Number).......................... [Knob 1]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be remixed.
10 STEREO TO MONO
NOTE
This parameter is not available when the speci-
fied sample is a Pitched Voice.
5
6
12 3
4
[Knob 1] [Knob 2]
[Knob 3]
[F4]
[F2]
[F3]
11 LOOP REMIX
87
[Knob 2] [F3]
67
412 3
5
[Knob 1]
[Knob 2] [Knob 3] [Knob 4]
[F2]
[F3]
[F4]