Filter
Top Products
2
The Pattern Mode
2. Combining Phrases to Create Patterns (Patch)
RS7000 75
Phrases can be combined to create patterns.
Pressing the [PATTERN] button alternately selects the PATTERN Play page and this page (PATTERN
Patch).
Display Parameters
1 PHRASE CAT. (Phrase Category)..............[Knob 1]
2 PHRASE NO. (Phrase Number)
...........................[Knob 2], [SHIFT]+[F2] → Numeric Keypad
[Settings]
Phrase Category No Phrase, US (User)
For more information on the pre-
set phrase categories refer to
Appendix (Page 313).
Phrase Number 001 ~ 256 (the actual range will
depend on the selected phrase
category)
Select a phrase category and phrase number to assign a
phrase to the currently selected track.
3
NOTE SHIFT
...........................[Knob 3], [SHIFT]+[F3] → Numeric Keypad
[Settings] -127 ~ +127 (semitones)
Shifts the pitch of the note data in the current phrase up or
down in semitone increments.
4
Phrase
Displays the phrases assigned to each track. Phrase assign-
ment is accomplished using [Knob 1] and [Knob 2].
The phrase “boxes” on the display indicate the following:
.............A user phrase which contains no data.
.............The phrase is shorter than the specified
length of the pattern.
.............The phrase is longer than the specified
length of the pattern.
.............The phrase is shorter than the specified
length of the pattern.
5
PHRASE METER, PHRASE LENGTH
Displays the meter and length in measures of the phrase
assigned to the currently selected track.
6
SEC (Section)
[Settings]
Section A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P
Displays the currently selected section.
7
MEAS (Measure)
8 LENGTH
MEAS displays the current measure during playback.
Length is the length of the pattern in measures.
2. Combining Phrases to Create Patterns (Patch)
NOTE
See page 72 in “1. Pattern Playback” for the
track selection procedure.
NOTE
If a phrase which uses a drum kit voice is note-
shifted, the drum instrument sounds will
change.
6 7 8
21
0
3 5
4
9
[Knob 1] [Knob 2]
[SHIFT]+[F2]
[Knob 3]
[SHIFT]+[F3]
NOTE
See page 72 in “1. Pattern Playback” for the
section selection procedure.
NOTE
The [ ], [ ], and [ ] buttons can be used
to change the measures number (also during
playback).