Filter
Top Products
3. Basic Operation
68 RS7000
Tap Tempo Entry
With this function you can enter a BPM setting by tapping the
[TAP] button at the appropriate tempo.
Tap the [TAP] button 3 or 4 times in the PATTERN, PATTERN
CHAIN, or SONG mode to automatically enter the correspond-
ing BPM.
Free Memory Display
If you press [UTILITY] while holding [SHIFT], the amount of
free memory will be shown while the buttons are held. The
amount of recordable memory (the amount of memory available
for recording or loading samples) may increase if the utility mode
wave memory optimize function is executed.
This will not be displayed while standing by for sequence or sam-
ple recording, or during recording.
Initializes the Master Effect settings
Press [MASTER] while holding [SHIFT] to initialize the cur-
rently selected master effect.
Undo/Redo
The Undo job cancels the changes made by the most recent oper-
ation, restoring the data to its previous state.
The Redo job cancels Undo and restores the changes.
Undo/Redo can be executed from any display page except Save,
Load and Edit by pressing the [JOB] button while holding the
[SHIFT] button. Undo and Redo are selected alternately each
time the [JOB] button is pressed.
Auto Repeat
The sequencer [ ] and [ ] buttons include an auto key
repeat function. Hold either button to continuously scroll through
the measures in the corresponding direction.
Auto Load
If the power is turned on while holding one of the white keys on
the keyboard as listed below, the Auto Load function will be acti-
vated and the corresponding file will be loaded automatically.
Files to be loaded using the Auto Load function must initially be
created and saved via the appropriate mode SAVE page with the
file name “AUTOLOAD_1” ~ “AUTOLOAD_9”, using the
“ALL” file type.
Once a file has been set it will be automatically loaded without
having to press a keyboard key.
White Key [1] ................AUTOLD_1.R2A
White Key [2] ................AUTOLD_2.R2A
White Key [3] ................AUTOLD_3.R2A
White Key [4] ................AUTOLD_4.R2A
White Key [5] ................AUTOLD_5.R2A
White Key [6] ................AUTOLD_6.R2A
White Key [7] ................AUTOLD_7.R2A
White Key [8] ................AUTOLD_8.R2A
White Key [9] ................AUTOLD_9.R2A
White Key [10] ..............Auto Load function Off
For example, if you’re working on a project but need to stop and
turn the power off for a while, save the project with the file name
“AUTOLD_1”. Then, hold the [1] white key when you turn the
power back on and the project will be automatically reloaded.
NOTE
• Undo/Redo cannot be used during sequencer
playback or recording, or while the arpeggio
function is operating.
• Undo/Redo does not work with sample voice
operations.
PAD ASSIGN
TAP
BPM
Tap several times to set the tempo.
NOTE
• If a SCSI drive is connected, first a memory
card will be searched in file order, then drives
with SCSI IDs 0 ~ 7 will be searched in order,
and the first matching file located will be
loaded.
• The “AUTOLD_1.R2A” file is set to be loaded
automatically as the factory default.