Filter
Top Products
SCPI Commands for the VX4101A
3–8
VX4101A MultiPaq Instrument User Manual
NOTE. While the instrument is initiated, any command or query which would
cause the instrument to change its configuration or start a new measurement will
first cause the instrument to abort immediately. After this implicit abort has been
issued, the ABORt bit of the Operational Status Register will toggle to signal
that the abort has completed and the new command or query will be executed.
NOTE. If a query (as opposed to a command) is currently in progress, the
behavior of the instrument will depend upon the communications protocol in
effect. If the instrument is in asynchronous mode, a new command or query can
be sent while a query is in progress and the implied abort will occur. If, however,
the instrument is in synchronous mode, the command or query will be queued
while the current query completes. This is a ramification of the IEEE 488.2
Message Exchange Protocol Enforcer (MEPE).
N/A
ABORt[:COMPlete]
Command Response
INST:SEL DAC
trac:srat 10000
trac:poin 10
trac:data
1,1,1,2,3,4,5,6,7,8,9,0
trig:mode seq,100
init:cont
trac:ind? 21,3
abor:comp
trac:ind? 1,1
ABORt[:IMMediate]
Command Response
INST:SEL DMM
CONF:ARR:VOLT:DC 512
INIT
FETC:COUN? 127
Query Response
Examples