Filter
Top Products
SCPI Commands for the SurePatht Modules
3–270
VX4101A MultiPaq Instrument User Manual
Command Module
[ROUTe:]MODule:CATalog? Valid for all SurePatht modules.
[ROUTe:]MODule[:DEFine] Valid for all SurePatht modules.
[ROUTe:]MODule:DELete:ALL Valid command for all SurePathtmodules.
[ROUTe:]MODule:
DELete[:NAME]
Valid command for all SurePathtmodules.
[ROUTe:]OPEN<channel list> Valid command for VX4330, VX4350, VX4351, and VX4380
SurePathtmodules
[ROUTe:]OPEN:ALL Valid command for VX4330, VX4350, VX4351, and VX4380
SurePathtmodules
[ROUTe:]OPEN:DWELl Valid command for VX4330, VX4350, VX4351, and VX4380,
SurePathtmodules
[ROUTe:]PFAil
<action_at_powerfail>
Valid command for VX4330, VX4350, and VX4380 Sur-
ePathtmodules
[ROUTe:]SCAN<channel_list> Valid command for VX4330, VX4350, VX4351, and VX4380
SurePathtmodules
[ROUTe:]SCAN:RATE Valid command for the VX4330 only
Parameters Value
<channel_list> Open
[ROUTe:]:DWEL1
<module_name>,<nrf>
0 seconds
[ROUTe:]CLOSe:MODE All sections of the SurePatht VX4330 Module are set to
operate in the mux mode. One or more channels in a section
may be closed at the same time.
[ROUTe:]CONFigure The section numbers specified in the <section_list> portion of
this command must be between 1 and 6. The configurations of
each applicable instrument must be:
VX4330: FWIRE
VX4351: OWIRE
[ROUTe:]CONFigure:DISJoin All sections on the VX4330 module are disjoined.
[ROUTe:]ID? N/A
[ROUTe:]CONFigure:JOIN All sections on all modules are disjoined.
[ROUTe:]MODule:CATalog? N/A
[ROUTe:]MODule[:DEFine] Default module names are assigned as follows:
The module that is immediately to the right of the Sur-
ePathtMaster.
Consecutive slots to the right of module “M1” are assigned
module names “M2”, “M3”, ..., “M11”.
*RST Value