Filter
Top Products
SCPI Commands for the Counter
VX4101A MultiPaq Instrument User Manual
3–111
H During continuous single-shot, or array measurements, one of the following
actions take place:
a. The firmware behaves as described above for single-shot measurements.
It checks the coincident bit for each measurement and returns the
calibrated delay value if it is set. No errors are generated.
H During gated measurements, using either an external gate, events mode
where events are larger than 1, or aperture mode where the aperture is longer
than just a single event:
The firmware will check the coincidence bit at the end of the gate. If it is set,
it will still return its calculated answer, but it will also generate an error
condition. You can set up the status registers to interrupt on such an error.
N/A
STATus:OPERation:CONDition?
Instrument
The operational condition register value.
0
N/A
Query Response
Numeric
MEASure?
READ?
INITiate
ABORt
The STATus:OPERation:CONDition query returns the current operational status
of the Counter. The bit definitions of the value are (bit 0 = the least significant
bit):
Command Syntax
Query Syntax
Command Class
Query Response
*RST Value
Limits
Formats
Related Commands
Description