Filter
Top Products
VX4101A MultiPaq Instrument User Manual
3–201
SCPI Commands for the Digital Multimeter
This section contains summaries of SCPI commands for the Digital Multimeter
(DMM) instrument in the VX4101A MultiPaqtInstrument. You can use the
commands to calibrate the instrument, define the types of measurements you
want to make, the voltage levels you want to use, begin the measurement, and
retrieve measurement results.
Command Summary
The following is a listing of the available command subsystems and syntax:
Commands
CALCulate:LIMit
:ENVelope[:DATA] <threshold1>,<threshold2>
:LOWer[:DATA] <threshold>
:REPort[:DATA]
:UPPer[:DATA] <threshold>
CALCulate:TRANsform:HISTogram:COUNt <numeric_value>
CALCulate:TRANsform:HISTogram:POINts <numeric_value>
CALCulate:TRANsform:HISTogram:RANGe <min>,<max>
CALCulate:TRANsform:HISTogram:RANGe:AUTO <ON|OFF>
Queries
CALCulate:AVERage? [<count>[,<offset>[,<step_size>]]]
CALCulate:LIMit:ENVelope[:DATA]?
CALCulate:LIMit:FCOunt?
CALCulate:LIMit:LOWer[:DATA]?
CALCulate:LIMit:REPort[:DATA]?
CALCulate:LIMit:UPPer[:DATA]?
CALCulate:MEDian?[<count>[,<offset>[,<step_size>]]]
CALCulate:MINimum?[<count>[,<offset>[,<step_size>]]]
CALCulate:MAXimum?[<count>[,<offset>[,<step_size>]]]
CALCulate:SDEViation?[<count>[,<offset>[,<step_size>]]]
CALCulate:TRANsform:HISTogram?
:ABOVe?
:BELow?
:COUNt?
:POINts?
CALCulate Subsystem