Filter
Top Products
SCPI Commands for the Digital Multimeter
3–222
VX4101A MultiPaq Instrument User Manual
CONFigure Subsystem
The CONFigure commands enable you to set up the DMM for a specific type of
input measurement.
CONFigure([:SCALar]|:ARRay)
[:VOLTage]
:AC [<Array Size>[,<Expected Value>[,<Resolution>]]]
:ACDC [<Array Size>[,<Expected Value>[,<Resolution>]]]
:DC [<Array Size>[,<Expected Value>[,<Resolution>]]]
:CURRent[:DC] [<Array Size>[,<Expected
Value>[,<Resolution>]]]
:RESistance [<Array Size>[,<Expected Value>[,<Resolution>]]]
:FRESistance [<Array Size>[,<Expected Value>[,<Resolution>]]]
NOTE. If SCALar is specified, the <array size> parameter is not valid. If ARRay
is specified, <array size> is a required parameter.
CONFigure?
Parameter Value
CONFigure([:SCALar]|:
ARRay)[:...]
300 VDC,
10 MW Input,
0.001 Resolution,
Autoranging ON
Parameter Value
<Array Size> 1 to 4096
NOTE: See MEASure? Command for more information on the <Expected Value> parameter.
See [SENse][...]:RESolution command for more information on the RESolution parameter.
Command Syntax
Query Syntax
*RST Value
Limits