Filter
Top Products
SCPI Commands for the SurePatht Modules
VX4101A MultiPaq Instrument User Manual
3–291
TRIGger([:SEQuence]|STARt[LAYer]:COUNt <count>
Two VX4330 Modules are installed in the slots next to the VX4101A. The de-
fault module names “m1” and “m2” have been assigned.
Command Response
route:conf twire,m1,(1:6) Set the configuration of all six sections of the first VX4330 to
20-to-1 2-wire
route:conf fwire,m2,(1:3) Set the configuration of sections 1 through 3 of the second
VX4330 to 10-to-1 4-wire
configure owire,m2,(4:6) Set the configuration of sections 4 through 6 of the second
VX4330 to 40-to-1 1-wire
scan(@m1(1!5:20!5),m2(1!3:1
0!3,1!6:40!6))
Define a scan list consisting of 2-wire channels 1 through 20 in
section 5 of the first VX4330, 4-wire channels 1 through 10 in
section 3 of the second VX4330 and 1-wire channels 1 through
40 in section 6 of the second VX4330
trigger:sequence:count 2 Define the number of times to sequence through the scan list
before setting the state of the trigger subsystem back to the
idle state
trigger:sequence:
source immediate
Sequence through the scan list without waiting for a trigger
event after an INITiate[:Immediate] command is received
initiate:immediate Initiate the scan sequence. Sequence through the entire scan
list two times
TRIGger([: SEQuence1] |:STARt) [:LAYer]:IMMediate
Command Response
TRIG:SOUR:CAT? HOLD, IMMEDIATE, BUS, TTLTRG0, TTLTRG1, TTLTRG2,
TTLTRG3, TTLTRG4, TTLTRG5, TTLTRG6, TTLTRG7,
COMMAND0, COMMAND1, COMMAND2, COMMAND3,
COMMAND4, TIMER, SUREPATH, DMM, COUNTER,
CTR_EXTARM
INST:SEL DMM Select DMM
CONF:ARR:RES 4 Configure for 4 resistance readings
TRIG:MODE:ONCE Require a separate trigger for each
TRIG:SOUR SUREPATH Select DMM Trigger source as SurePatht
INIT Initiate and wait for trigger
INST:SEL SUREPATH Select SurePatht instrument
ROUT:SCAN (@m1
(1!1!1,1!2!1,1!3!1,1!4!1))a
Program a 4 channel scan list for the VX4380
ROUT:CLOS:DWEL m1, .3 0.3 second delay from channel close to trigger
TRIG:SOUR DMM Select SurePatht trigger source as DMM
INIT Initiate and wait for trigger
Examples