Filter
Top Products
SCPI Commands for the SurePatht Modules
VX4101A MultiPaq Instrument User Manual
3–279
Command Response
close (@m3(40!3)) Open all channels in sections 1 through 3 of the third VX4330,
then close channel 40 of section 3.
close? (@m3(1!1:40!3)) 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1
[ROUTe:]CONFigure
In this example, three additional VX4330 Modules are installed in consecutive
slots to the right of the VX4101A.
Command Response
route:configure fwire,m1,(1:6) Configure all six sections of the first VX4330 as 10-to-1 4-wire
scanners
route:close:mode
scan,m1,(1:3)
Set the mode of operation of sections 1, 2, and 3 of the first
VX4330 to scan. In this mode, only one channel in a section is
closed at a time
route:close:mode
mux,m1,(4:6)
Set the mode of operation of sections 4, 5 and 6 of the first
VX4330 to mux. In this mode one or more channels in a
section may be closed at the same time
rout:conf owire,m3,(1) Configure section 1 of the third VX4330 as a 40-to-1 1-wire
scanner
rout:conf twire,m2,(2,3) Configure sections 2 and 3 of the second VX4330 as 20-to-1
2-wire scanners
route:configure fwire m3,(1:6) Configure all six sections of the third VX4330 as 10-to-1 4-wire
scanners with independent control of upper and lower halves of
the 4-wire common
route:close (@m3(1!1)) Connect the lower half of channel 1, section 1, to the lower half
of the 4-wire common. In this example, section 1 is assumed to
be configured as a 10-to-1 4-wire scanner with independent
control of the upper and lower halves of the 4-wire common
route:close (@m3(20!1)) Connect the upper half of the tenth channel of section 1 to the
upper half of the 4-wire common. In this example, section 1 is
assumed to be configured as a 10-to-1 4-wire scanner with
independent control of the upper and lower halves of the 4-wire
common