Filter
Top Products
SCPI Commands for the SurePatht Modules
VX4101A MultiPaq Instrument User Manual
3–269
[ROUTe:]Configure <configuration>,<module_name>,<section_list>
:DISJoin <module name>
:JOIN <module_name>,<section_list>
[ROUTe:]MODule
:DELete[:NAME] <module_name>
:DELete:ALL
[:DEFine] <module_name>, <nrf>
[ROUTe:]OPEN <channel_list>
:ALL [module_name]
:DWELl <module_name>, <nrf>
[ROUTe:]PFAil <action_at_powerfail>
[ROUTe:]SCAN <channel_list>
:RATE <scan_rate>,<module_name>
[ROUTe:]CLOSe? <channel_list>
[ROUTe:]ID?
[ROUTe:]MODule
[:DEFine]? <module_name>
:CATalog?
:CATalog:SUPPorted?
[ROUTe:]OPEN? <channel_list>
The following table shows which command is used for a specific SurePath
t
module.
Command Module
[ROUTe:]CLOSe
<channel_list>
Valid for all SurePatht modules.
[ROUTe:]:DWEL1
<module_name>,<nrf>
Valid for all SurePatht modules.
[ROUTe:]CLOSe:MODE Valid for VX4330 modules only.
[ROUTe:]CONFigure Valid for VX4330, VX4351 only.
[ROUTe:]CONFigure:DISJoin Valid for VX4330 modules only.
[ROUTe:]ID? Valid for all SurePatht modules.
[ROUTe:]CONFigure:JOIN Valid for VX4330 modules only.
Query Syntax
SurePatht Module