Filter
Top Products
SCPI Commands for the SurePatht Modules
3–282
VX4101A MultiPaq Instrument User Manual
Command Response
route:module:define matrix,2 Assign module name “matrix” to the VX4380
route:close (@matrix(4!16!3)) Close the relay at row 4, column 16 in section 3 of the VX4380
route:module:define?
gp_switch
1
module:define
scanner,3
Assign module name “scanner” to the VX4330
open:all scanner Open all channels on the VX4330
route:conf owire,
scanner,(1:6)
Set the configuration of all sections of the VX4330 to 40 to 1
one wire
close (@scanner(30!2)) Close channel 30 of section 2 on the VX4330
module? scanner 3
[ROUTe:]MODule:DELete:ALL
Command Response
route:module:catalog? “M1”, “M2”, “M3”
route:module:
delete:all
Delete all module names
route:module:catalog? “ ”
[ROUTe:]MODule:DELete[:NAME]
Command Response
route:module:catalog? “M1”, “M2”, “M3”
route:module:delete m1 Delete module name “M1”
route:module:catalog? “M2”, “M3”
[ROUTe:]OPEN<channel list>
Three additional VX4330 Modules are installed in consecutive slots to the right
of the first VX4101A. The default module names for these three modules are m1,
m2, and m3. These module names may be altered with the [ROUTe:]MOD-
ule[:DEFine] command.
Command Response
route:open:dwell m1,.1 Assign an open dwell time of 0.1 seconds to the first VX4330
route:open:dwell m2,.2 Assign an open dwell time of 0.2 seconds to the second
VX4330
route:open:dwell m3,.5 Assign an open dwell time of 0.5 seconds to the third VX4330