Yamaha ES6 Recording Equipment User Manual


  Open as PDF
of 300
 
Quick Guide — Advanced Course
Creating a Song on the MOTIF ES
134
Owner’s Manual
Move the cursor to the file (extension: W7A) which was saved as “All” on previous page.
When Type is set to “All,” go to step #5.
When Type is set to something other than “All,” follow the instructions below then go to step #5.
● When Type is set to “Voice” or “Performance”:
You can select and load a specified Voice or Performance in the file (extension: W7A) to this instrument.
● When Type is set to “Song” or “Pattern”:
You can select and load a specified Song or Pattern in the file (extension: W7A) to this instrument.
● When Type is set to “Waveform”:
You can select and load a specified Waveform in the file (extension: W7A) to this instrument.
In this case, the destination differs depending on the mode selected before entering the File mode.
4
Select a file ( ) to be loaded.
When entering the File mode from the Voice mode: Set the Voice bank and number as the destination.
When entering the File mode from the Performance mode: Set the Part of the current Performance then set the Voice bank/number of the Part as the
destination.
When entering the File mode from the Song mode/Pattern mode: Set the track of the current Song/Pattern as the destination.
ENTER
EXECUTE
ENTER
EXECUTE
Move the cursor to the file (extension:
W7A) which was saved as “All” on
previous page.
All Voices or Performances in the
selected file are listed. Move the
cursor to the desired Voice or
Performance to be loaded.
Select the destination Voice number
or Performance number.
Select the desired Voice or
Performance.
ENTER
EXECUTE
ENTER
EXECUTE
Move the cursor to the file (extension:
W7A) which was saved as “All” on
previous page.
All Songs or Patterns in the
selected file are listed. Move the
cursor to the desired Song or
Pattern to be loaded.
Select the destination Song number
or Pattern number.
Select the desired Song or Pattern.
ENTER
EXECUTE
ENTER
EXECUTE
Move the cursor to the file (extension:
W7A) which was saved as “All” on
previous page.
All Waveforms in the selected file
are listed. Move the cursor to the
desired Waveform to be loaded.
Select the destination. (See below.)
Select the desired Waveform.
 previous next