Filter
Top Products
Reference Voice Mode
Voice Edit mode Normal Voice Edit Common Edit
193
Owner’s Manual
TempoSync Determines whether or not the LFO is synchronized to the tempo of the Arpeggio or sequencer (song or pattern).
Settings: off (not synchronized), on (synchronized)
TempoSpeed This parameter is available only when TempoSync above has been set to “on.” It allows you to make detailed note
value settings that determine how the LFO pulses in sync with the Arpeggio or sequencer.
Settings: 16th, 8th/3 (eighth-note triplets), 16th. (dotted sixteenth notes), 8th, 4th/3 (quarter-note triplets), 8th. (dotted eighth notes), 4th
(quarter notes), 2nd/3 (half-note triplets), 4th. (dotted quarter notes), 2nd (half notes), whole/3 (whole-note triplets), 2nd.
(dotted half notes), 4th x 4 (quarter-note quadruplets; four quarter notes to the beat), 4th x 5 (quarter-note quintuplets; five
quarter notes to the beat), 4th x 6 (quarter-note sextuplets; six quarter notes to the beat), 4th x 7 (quarter-note septuplets;
seven quarter notes to the beat), 4th x 8 (quarter-note octuplets; eight quarter notes to the beat)
n The actual length of the note depends on the internal or external MIDI tempo setting.
KeyOnReset Determines whether or not the LFO is reset each time a note is pressed. The following three settings are available.
Settings: off, each-on, 1st-on
off.....................The LFO cycles freely with no key synchronization. Pressing a key starts the LFO wave at whatever phase the LFO
happens to be at that point.
each-on ...........The LFO resets with each note you play and starts a waveform at the phase specified by the Phase parameter (below).
1st-on ..............The LFO resets with every note you play and starts the waveform at the phase specified by the Phase parameter
(below). However, if you play a second note while the first is being held, the LFO continues cycling according to the
same phase as triggered by the first note. In other words, the LFO only resets if the first note is released before the
second is played.
RandomSpeed Determines the degree to which the LFO speed changes at random. A setting of “0” results in the original speed.
Higher values result in a larger degree of speed change.
Settings: 0 ~ 127
[SF2] DELAY
Delay (Delay Time) Determines the delay time before the LFO comes into effect. A higher value results in a longer delay time.
Settings: 0 ~ 127
FadeIn (Fade In Time) Determines the amount of time for the LFO effect to fade in (after the Delay time has elapsed). A higher value results
in a slower fade-in.
Settings: 0 ~ 127
Hold (Hold Time) Determines the length of time during which the LFO is held at its maximum level. A higher value results in a longer
Hold time.
Settings: 0 ~ 127
FadeOut Determines the amount of time for the LFO effect to fade out (after the Delay time has elapsed). A higher value
results in a slower fade-out.
Settings: 0 ~ 127
Time
Key on
Key on
(second note)
Time
Key on
(first note)
Key on
(second note)
Time
Key on
(first note)
off
each-on
1st-on
FadeIn
Max
Time
Key on
FadeIn
Delay
Time
Key on
Max
Delay
Low FadeIn value
Faster fade-in
High FadeIn value
Slower fade-in
Hold
Time
Max
FadeOut
Hold
Max
Time
FadeOut
Time
Hold
Max
Low FadeOut value
Faster fade-out
Low FadeOut value
Faster fade-out