Filter
Top Products
Reference Voice Mode
Voice Edit mode Drum Voice Edit Key Edit
204
Owner’s Manual
[SF2] VEL SENS
(Velocity Sensitivity)
LPFCutoff Determines the velocity sensitivity of the Low Pass Filter Cutoff frequency. For positive settings, the more strongly
you play the keyboard, the higher the cutoff frequency becomes. For negative settings, the more strongly you play,
the lower the cutoff frequency.
Settings: -64 ~ 0 ~ +63
[F4] AMP (Amplitude)
[SF1] LVL/PAN (Level/Pan)
This display not only lets you make basic Level and Pan settings for the sound of each individual Drum key, it also
gives you some detailed and unusual parameters for affecting Pan position.
Level Determines the output for the selected Drum key (Wave). This lets you make detailed balance adjustments among
the various sounds of the Drum voice.
Settings: 0 ~ 127
Pan Determines the stereo Pan position for the selected Drum key (Wave). This will also be used as the basic Pan
position for the Alternate and Random settings.
Settings: L63 (Left) ~ C (Center) ~ R63 (Right)
AlternatePan Determines the amount by which the sound of the selected Drum key is panned alternately left and right for each
note you press. The Pan setting (above) is used as the basic Pan position.
Settings: L64 ~ 0 ~ R63
n This parameter is available when the Type is set to “pre wav” or “usr wav” in the [F1] OSC → [SF1] WAVE display (page 202).
RandomPan Determines the amount by which the sound of the selected Drum key is panned randomly left and right for each note
you press. The Pan setting (above) is used as the Center Pan position.
Settings: 0 ~ 127
n This parameter is available when the Type is set to “pre wav” or “usr wav” in the [F1] OSC → [SF1] WAVE display (page 202).
[SF2] VEL SENS
(Velocity Sensitivity)
Level Determines the velocity sensitivity of the Amplitude Envelope Generator's output level. Positive settings will cause
the output level to rise the harder you play the keyboard and, conversely, negative values will cause it to fall.
Settings: -64 ~ 0 ~ +63
[SF3] AEG
(Amplitude Envelope Generator)
AttackTime
Settings: 0 ~ 127
Decay1Time
Settings: 0 ~ 127
Decay1Lvl (Level)
Settings: 0 ~ 127
Decay2Time
Settings: 0 ~ 126, hold
[F6] EQ (Equalizer)
Same as in Normal Voice Element Edit. See page 201.
n This parameter is available when the Type is set to “pre wav” or “usr wav” in the [F1] OSC → [SF1] WAVE display (page 202).
Attack level Attack level
Key on
Attack
time
Decay1
time
Decay2
time
Attack
time
Decay1
time
Decay2
time
Decay1 level Decay1 level
Key on
Level
Time Time
Level
Decay2Time=0 – 126
Decay2Time=hold