Filter
Top Products
Reference Voice Mode
Voice Edit mode Plug-in Voice Edit Element Edit
206
Owner’s Manual
FMod (Filter Modulation Depth) Determines the depth of control that keyboard aftertouch has over filter cutoff modulation. The higher the setting, the
greater the depth of control.
Settings: 0 ~ 127
AMod
(Amplitude Modulation Depth)
Determines the depth of control that keyboard aftertouch has over amplitude modulation. The higher the setting, the
greater the depth of control.
Settings: 0 ~ 127
[SF4] AC (Assignable Control)
From this display you can assign MIDI Control Change numbers (as Src) and determine the degree to which
the assigned controllers affect the filter and the modulation effects (pitch, filter and amplitude).
Src (Source) Determines the MIDI Control Change number used to control the filter, PMod, FMod, and AMod.
Settings: 0 ~ 95
Filter Determines the depth of control the Control Change numbers (set in the Src parameter above) have over the filter
cutoff frequency.
Settings: -64 ~ 0 ~ +63
PMod (Pitch Modulation Depth) Determines the depth of control the Control Change messages (set in the Src parameter above) have over pitch
modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
FMod (Filter Modulation Depth) Determines the depth of control the Control Change messages (set in the Src parameter above) have over filter
cutoff modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
AMod
(Amplitude Modulation Depth)
Determines the depth of control the Control Change messages (set in the Src parameter above) have over amplitude
modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
[F6] EFFECT
Same as in Normal Voice Common Edit. See page 194.
Please note that the EL: OUT settings are not available in the [SF1] CONNECT display and the parallel setting (Insertion Connection) is not available in the [SF1]
CONNECT display.
Element Edit
[VOICE] → Plug-in Voice selection → [EDIT] → Element selection
[F1] OSC (Oscillator)
[SF1] WAVE
From this display you can select the desired Board Voice used for the Element of the Plug-in voice. Keep in mind that
a Plug-in voice only has one Element.
Bank Determines the Board Voice Bank.
Settings: These depend on the particular Plug-in board; refer to the relevant owner’s manual for details.
Number Determines the Board Voice Number.
Settings: These depend on the particular Plug-in board; refer to the relevant owner’s manual for details.
[SF5] OTHER
VelocityDepth Determines the velocity sensitivity of the Plug-in Voice. For higher values, the harder you play the keyboard, the
louder the voice becomes.
Settings: 0 ~ 127
VelocityOffset This lets you specify an offset value for Velocity Depth (above). In other words, you can increase the relative velocity
(or level) of the voice by a set amount – so that all the notes you play have the added velocity.
Settings: 0 ~ 127
NoteShift Determines the transpose setting for the Plug-in voice, or the amount (in semitones) by which the pitch is raised or
lowered. The pitch range is two octaves, up or down.
Settings: -24 ~ 0 ~ +24