Filter
Top Products
Basic Structure
Internal Structure (System Overview)
155
Owner’s Manual
Controller related parameters in each mode
The chart below shows the operations for calling up the Controller related parameters in each mode. Parameters for the
Footswitch and the Assign Knobs A/B apply to the entire instrument, regardless of the selected program (Voice/Performance/
Song/Pattern).
Aside from their default control parameters, the controllers of the instrument, such as the Pitch Bend wheel and the Modulation
wheel, can be freely assigned to a variety of different parameters. For example, you could assign Resonance to the Modulation
Wheel and set aftertouch to apply vibrato. These settings for all the controllers are referred to as a “Controller Set,” and up to six
Controller Sets can be created for each Voice.
● Source and Destination
“source” refers to the hardware controller and “destination” refers to the parameter or function being controlled. An extensive
variety of destination parameters are available, far more than those listed above. For a complete list of destination parameters,
see the separate Data List.
Voice mode
Controller Set (for each Voice) [VOICE] → Voice selection → [EDIT] → [COMMON] → [F4] CTL SET See below.
Assigning the Control Change number to each
Controller (for all Voices)
[VOICE] → [UTILITY] → [F3] VOICE → [SF4] CTL ASN Page 262
Performance
mode
Assigning the Control Change number to each
Controller (for each Performance)
[PERFORM] → Performance selection → [EDIT] → [COMMON] →
[F4] CTL ASN
Page 214
Song mode
Assigning the Control Change number to each
Controller (for each Song Mixing)
[SONG] → Song selection → [MIXING] → [EDIT] → [COMMON] →
[F4] CTL ASN
Page 234
Pattern mode
Assigning the Control Change number to each
Controller (for each Pattern Mixing)
[PATTERN] → Pattern selection → [MIXING] → [EDIT] → [COMMON] →
[F4] CTL ASN
Page 248
All modes
Assigning the function and Control Change
number to the Assign Knob A/B
[UTILITY] → [F4] CTL ASN → [SF2] ASSIGN Page 263
Assigning the function and Control Change
number to the Footswitch (connected to the
ASSIGNABLE connector)
[UTILITY] → [F4] CTL ASN → [SF3] FT SW Page 263
Controller Set
[VOICE] →→
→→
Voice selection →→
→→
[EDIT] →→
→→
[COMMON] →→
→→
[F4] CTL SET Page 192
SWING GATE TIME
LOW
KN
1
LOW MID
KN
2
1
ON/OFF ON/OFF ON/OFF ON/OFF
234
Voice
Controller Set 1 - 6
Volume, Reverb Send Level, Chorus Send Level, Filter
Cutoff Frequency, Filter Resonance, etc.
Controller Set
Source = Controller
Depth = Degree to which the
controller affects the sound
Element Switches
Destination (Dest) = function
n You can set whether the controller affects each
Element by setting the Element Switch on or off as
desired. Note that this applies only to Normal Voices.
n The Element Switch parameters are not available
when a function unrelated to Elements (1 - 40) is set
as the destination.