Filter
Top Products
Quick Guide — Advanced Course
Editing a Performance
91
Owner’s Manual
Editing a Performance by using the Con-
trol Sliders (CS)
In the Performance mode, the four Control Sliders let you
independently adjust the levels of the Parts (Voices), letting you
control the overall balance of the Parts.
n Inadvertent use of the sliders may result in no sound. If this
occurs, move the sliders upward.
Edit Recall
If you are editing a Performance and select a different
Performance without storing the one you were editing, all the edits
you’ve made will be erased. If this happens, you can use Edit
Recall to restore the Performance with your latest edits intact.
1 Press the [JOB] button in the Performance mode to
enter the Performance Job mode.
2
Press the [F2] RECALL button to call up the Recall display.
3 Press the [ENTER] button. (The display prompts you
for confirmation.)
If you wish to cancel the operation, press the [DEC/NO]
button.
4
Press the [INC/YES] button to execute the Edit Recall
to restore the Performance.
Storing/Saving the created Performance
Two steps are necessary in order to store (save) your Performance – storing the edited Performance to internal memory and saving the stored
Performances to a SmartMedia/USB storage device.
Keep in mind that edited Performance data is stored to internal User memory (Flash ROM) and is stored even when turning the power off. As
such it is not necessary to save the data to SmartMedia card or another device; however, you may want to save it to another media for backup or
organizational purposes, using the Save operation.
Storing the edited Performance as a User Performance to internal memory
Make sure to execute the Store operation before selecting another
Performance.
Select a Performance number by using the data dial, [INC/YES] and
[DEC/NO] button.
When you execute the Store operation, the settings for the destination
memory will be overwritten. Important data should always be backed up to
a separate SmartMedia/USB storage device.
The display prompts you for confirmation.
To cancel the Store operation, press the [DEC/NO] button.
[PERFORM] →→
→→
Performance selection →→
→→
[EDIT] →→
→→
Part selection →→
→→
[F2] OUTPUT →→
→→
[SF1] VOL/PAN
→→
→→
Volume
TIP
Performance Edit
STORE SAVE
USB storage
device
SmartMedia
Performance 001
Performance 002
Performance 003
Performance 128
Internal memory
(Flash ROM)
Storing edited
Performances individually
All the User
Performance data in
internal memory can
be saved as a single
file.
File extension: W7A
[PERFORM] → [STORE]
1
After editing the Performance, press the [STORE]
button to enter the Performance Store mode.
2
Select the destination Performance memory.
3
Press the [ENTER] button.
CAUTION
EXIT ENTER
EXECUTE