Filter
Top Products
Reference Performance Mode
Performance Edit mode Common Edit
213
Owner’s Manual
Voice Edit parameters are divided into Common Edit (parameters common to all four Parts), and Part Edit (parameters of individual Parts).
[F5] EG (Envelope Generator)
This display contains the basic EG settings, both volume and filter, for the Performance, as well as the filter’s cutoff frequency and resonance settings. The settings
made here are applied as offsets to the AEG and FEG settings in the Performance Edit mode (pages 218, 219).
The parameters are same as in Voice Play mode. See page 189.
[F6] ARP (Arpeggio)
This display contains the basic settings for Arpeggio playback, including Type and Tempo. Note that the Performance mode lets you independently enable or
disable Arpeggio playback for each Part.
The parameters are same as in the Voice Play mode (page 189) except for the following one.
PartSw Determines whether Arpeggio is on or off for the selected Part. The Parts for which boxes are checkmarked are
enabled for Arpeggio play.
Performance Edit mode
[PERFORM] → Performance selection → [EDIT]
Common Edit
[PERFORM] → Performance selection → [EDIT] → [COMMON]
[F1] GENERAL
[SF1] NAME
From this display you can assign the category (sub and main) of the selected Performance, and create a name for
the Performance. The Performance name can contain up to 10 characters. For detailed instructions on naming a
Performance, see “Basic Operation” on page 53.
[SF3] MEQ OFS
(Master EQ Offset)
From this display you can adjust the master (global) EQ settings for all Parts of the selected Performance. The level
of each of the four bands (with the exception of “MID”) can be adjusted. Moreover, you can also tweak these settings
directly from the four Knobs on the front panel. Editing by Knobs can be done in the Performance Play mode.
Settings: -64 ~ 0 ~+63
[SF4] PORTA (Portamento)
This display allows you to set the Portamento related parameters.
The parameters are the same as in the Performance Play mode. See page 212.
[SF5] OTHER
From this display you can set the control functions for the Knobs and related parameters.
With the exception of Pitch Bend, which cannot be set here, these parameters are the same as in the Voice Edit
mode (page 190).
[F2] OUT/MEF (Output/Master Effect)
[SF1] OUT (Output)
Volume Determines the output level of the selected Performance. You can adjust the overall volume, keeping the balance
between all Parts.
Settings: 0 ~ 127
Pan Determines the stereo pan position of the selected Performance. This parameter offsets the same parameter in the
Part Edit setting. You can also adjust this parameter using the PAN knob (with the [PAN/SEND] lamp turned on) on
the front panel. Editing by using the Knobs can be done also in the Performance Play mode.
Settings: L63 (Left) ~ C (Center) ~ R63 (Right)
n A setting of “C” (center) maintains the individual Pan settings of each Part.
RevSend Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the Reverb effect.
You can also adjust this parameter using the REVERB knob (with the [PAN/SEND] lamp turned on) on the front panel.
Editing by using the Knobs can be done also in the Performance Play mode.
Settings: 0 ~ 127
ChoSend Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the Chorus effect.
You can also adjust this parameter using the [CHORUS] knob (with the [PAN/SEND] lamp turned on) on the front
panel. Editing by using the Knobs can be done also in the Performance Play mode.
Settings: 0 ~127
n For details on Effect connections in the Performance mode, see page 179.