Filter
Top Products
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section 129
16
Remote control
If you set a value to SW, ENC, or FAD, that value will
be linked to the state of the controller. For example if
you have made settings as shown in the following
screen, the last value will be linked with the fader posi-
tion, and will change in the range of 0–127.
When you click a box in which a hexadecimal value has
been input, the range of values that can be interpreted
as a valid MIDI message (including that box) will turn
red. The lower part of the screen shows the MIDI chan-
nel (MIDI CH), message type (TYPE), and data values
(DATA 1, DATA 2) for this MIDI message, letting you
verify that the appropriate MIDI message has been
input.
You can use the following buttons to input or edit the
message in this window.
When you have finished inputting data in the MIDI
REMOTE SETUP window, click the OK button. The
hexadecimal values will be input in the MIDI message
box of the MIDI REMOTE screen.
B Specifying the type of message
In this method you specify the desired MIDI channel,
type of message, and data value; these will be con-
verted into the appropriate hexadecimal values. Access
the MIDI REMOTE SETUP window in the same way
as for method
1, and click the first box into which
you want to input data.
Next, click the / buttons at the left and right of the
TYPE box to select the type of message.
Then use the MIDI CH, DATA 1, and DATA 2 boxes
to specify the MIDI channel and various values. The
values that can be selected in the MIDI CH, DATA 1,
and DATA 2 boxes will depend on the type of message
you selected first.
If you set the DATA 1 or DATA 2 value to SWITCH,
ENCODER (available only for encoders), or FADER
(available only for faders), that value will be linked with
the state of the controller.
buttons Move the highlighted area to left or right.
INS button
Inserts a space (blank) at the highlighted
position. Pressing the <Insert> key of a
PS/2 keyboard will produce the same
result.
DEL button
Deletes the character at the highlighted
position. Pressing the <Delete> key of a
PS/2 keyboard will produce the same
result.
CLEAR button
Erases the entire message that was input
in the MIDI message input boxes.
PASTE button
Pastes the message that was copied to
buffer memory by the COPY button.
COPY button
Copies the message from the MIDI mes-
sage input box to temporary buffer mem-
ory. Use this in conjunction with the PASTE
button to copy a message from one con-
troller to another bank or controller.
TYPE MIDI CH DATA 1 DATA 2
NOTE OFF
1–16
Note number
(0–127)
Note-off velocity
(0–127)
NOTE ON
Note-on velocity
(0–127)
KEY PRES-
SURE
Pressure value
(0–127)
CONTROL
CHANGE
Control num-
ber (0–127)
Controller value
(0–127)
PROGRAM
CHANGE
Program
number
—
CHANNEL
PRESSURE
Pressure
value (0–127)
PITCH BEND
Pitch bend
MSB (0–127)
Pitch bend LSB
(0–127)
EXCLUSIVE
MESSAGE
—
Hexadecimal values that were input
Type of message