Filter
Top Products
2 Top, front, and rear panels
20 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section
Q GPI connector
This is a D-sub 25-pin female connector that allows
communication with a GPI-equipped external device.
R RS422 REMOTE connector
This is a D-sub 9-pin female connector for remotely
controlling an external device that supports the RS422
protocol.
S HA REMOTE connector
This is a D-sub 9-pin male connector for remotely con-
trolling an external head amp device (e.g., Yamaha
AD8HR or AD824) that supports a special protocol.
T WORD CLOCK IN connector
This is a BNC connector for supplying a word clock
from an external device to the PM5D.
U 75Ω ON/OFF switch
This switch terminates the word clock connection.
Normally you will leave this ON. If a device made by
another manufacturer is connected and word clock
cannot be received correctly, try turning this OFF.
V WORD CLOCK OUT connector
This is a BNC connector for supplying a word clock
from the PM5D to an external device.
W MIDI IN/THRU/OUT connectors
These connectors are used to transmit and receive
MIDI messages to and from external MIDI devices.
The MIDI IN connector receives messages from an
external device, and the MIDI OUT connector trans-
mits messages from the PM5D. Messages received at
the MIDI IN connector are retransmitted without
change from the MIDI THRU connector.
X 2TR OUT DIGITAL (2 track out digital) jacks
1–3
These jacks digitally output the signals of the STEREO
A/B channels. Two types are provided; AES/EBU
(XLR-3-32) jacks (1/2) which output AES/EBU format
signals, and a COAXIAL (RCA phono) jack (3) which
outputs consumer format signals (IEC60958).
Y 2TR IN DIGITAL (2 track in digital) jacks 1–3
These jacks input digital audio from external devices
such as CD players. Two types are provided; AES/EBU
(XLR-3-31) jacks (1/2) which receive AES/EBU format
signals, and a COAXIAL (RCA phono) jack (3) which
receives consumer format signals (IEC60958).
Z CASCADE OUT connector
This is a D-sub half-pitch 68-pin female connector that
can be connected to another PM5D, DSP5D, DCU5D
or DME64N for transmission/reception of control sig-
nals and transmission of audio signals.
a CASCADE IN connector
This is a D-sub half-pitch 68-pin female connector that
can be connected to another PM5D, DSP5D or
DCU5D for transmission/reception of control signals
and reception of audio signals.
b Cooling fan vent
This is the vent for the cooling fans inside the console
(two locations). When placing the unit, take care that
this vent is not obstructed.
c SLOT 1–4
These slots allow separately sold mini-YGDAI I/O
cards to be installed to expand the input/output ports.
Front panel
A MEMORY CARD slot
A memory card inserted in this slot can be used to
save/load scene memories or library data. You can use
PCMCIA Type II flash ATA cards, or CompactFlash
cards inserted into a PC card adaptor.
B MOUSE connector
A PS/2 mouse can be connected to this connector and
used to perform operations in the display.
C KEYBOARD connector
A PS/2 keyboard can be connected to this connector
and used to input text or perform operations in the
display.
D PHONES (Headphone) jack
This headphone jack lets you monitor the MONITOR
OUT or CUE signals.
cb
PHONES
KEYBOARD
MOUSE
MEMORY CARD
PHONES
KEYBOARD
MOUSE
MEMORY CARD
12
43
56
12
43
56
1 2 3 4