Filter
Top Products
OUTPUT PATCH function
246 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
In this screen you can select the position at which the
insert-in/out of each output channel will be patched. Here
you can also switch insert-in on/off.
A Insert view
When you move the cursor to the insert I/O point
(
4), the insert point for that output channel will be
shown graphically.
B OUTPUT CH (Output channel)
This is the number and name of the output channel
you are editing. Two paired channels are indicated by a
heart symbol shown at the left; settings
3–4 will be
linked for these channels. You can click this symbol to
enable/disable pairing.
C ON/OFF (Insert on/off)
This button switches insert on/off for each channel.
This is linked for paired channels.
Note
Be aware that if you turn on this button when either insert-in or
insert-out are unpatched, the signal will no longer be output
from the corresponding output channel.
D INSERT I/O (Insert I/O point)
Here you can select one of the following as the insert-
in/out location for each output channel.
E SET ALL
Turns on the corresponding item (insert or the insert
point) for all channels (including channels not cur-
rently shown in the screen).
F CLEAR ALL
Turns insert off for all channels (including channels
not currently shown in the screen).
INSERT POINT screen
INSERT POINT
1
PRE EQ Immediately before the EQ
POST EQ Immediately after the EQ
PRE FADER Immediately before the fader
POST ON Immediately after the [ON] key
2
56
3 4