Filter
Top Products
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section 281
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
For each input channel, you can specify the point at which
insert in/out will be patched, and the point from which
direct output will be taken. Here you can also switch Insert
or Direct Output on/off.
A Insert view
When you move the cursor to an insert I/O point (4),
the insert and direct output locations for that input
channel will be shown graphically.
B INPUT CH (Input channel)
This is the number of the input channel you are edit-
ing. Two paired channels are indicated by a heart
symbol shown at the left; settings
3–6 will be linked
for these channels. You can click this symbol to enable/
disable pairing.
C INSERT ON/OFF
This button switches insert on/off for each channel.
This is linked for two paired channels.
Note
Be aware that if you turn on this button when either insert-in or
insert-out are unpatched, the signal will no longer be output
from the corresponding input channel.
D INSERT I/O (Insert I/O point)
Here you can select one of the following as the insert-
in/out location for each channel.
E SET ALL
Turns on the corresponding item (insert or the insert
point) for all channels (including channels not cur-
rently shown in the screen).
F CLEAR ALL
Turns insert off for all channels (including channels
not currently shown in the screen).
INSERT/DIRECT OUT POINT screen
INSERT/DIRECT OUT POINT
1
PRE EQ Immediately before the EQ
POST EQ Immediately after the EQ
PRE DELAY Immediately before the delay
POST FADER Immediately after the fader
2
56
43