Filter
Top Products
19 Other functions
162 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section
If necessary, you can make fine adjustments in steps of
0.1 dB to the gain of the specified analog input port. Since
the input levels of all ports are set to match each other
when the PM5D is shipped from the factory, you will nor-
mally not need to change these settings.
Note
• Since these are set to optimal values at the factory, the
default values will differ between input ports. Initializing the
internal memory will return these settings to their factory-set
values.
• Fine adjustments of the DSP5D’s input/output gain should
be made from DSP5D Editor.
To adjust the gain, click the / buttons located at the
left and right of each box to specify the gain of each input
port in 0.1 dB units. If you want to restore all input ports
to their factory settings, click the FACTORY PRESET but-
ton. Click the OK button to apply the settings.
If necessary, you can make fine adjustments in steps of 0.01
dB to the gain of the specified output port. The factory set-
ting is 0.00 dB.
To adjust the gain, click the / buttons located at the
left and right of each box to specify the gain of each output
port in 0.01 dB units. If you want to reset all output ports
to 0.00 dB, click the FACTORY PRESET button. Click the
OK button to apply the settings.
Adjusting the analog input gain
(PM5D-RH model only)
Adjusting the output gain