Filter
Top Products
CONFERENCE (SIX/TEN PARTY)
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
Page 120
NDA-24271, Issue 1.0
CONFERENCE (SIX/TEN PARTY)
General Description
This feature permits a station user or Attendant (conference leader) to establish a Conference among as many
as six or ten parties (including the Conference leader).
Station Application
All stations and Attendant Consoles
Operating Procedure
Using the access code
• To make a Conference Call
1. The Conference leader goes off hook, or an Attendant presses a loop key.
2. Dial the access code (“A”) for a 6 or 10-party Conference and receive special dial tone. If the CFT trunks
are all busy or the leader is not assigned as the Conference leader with service feature class, reorder tone is
heard. If a participant's line (station or C.O./Tie line) is busy, repeat Step 2 after going on hook once (no
need to dial access code A again).
3. Dial the number of the first party to be added to the conference.
4. Press the Transfer key after the party answers and then dial the access code (“B”) to add then into the con-
ference.
5. Sequentially call all desired parties and connect them to the CFT trunk by dialing the assigned access code
B. The called party (station, C.O./Tie line) waits in the Conference mode until the leader is connected to the
CFT trunk.
6. After connecting the last participant to the CFT trunk, dial the access code B to enter the CFT trunk and
Conference can be started.
• To release a participant
1. Conference leader goes on hook, or an Attendant presses the RLS key.
2. Go off hook or press the loop key again. Dial the access code (“C”) for forced release dial the participant's
number. (Conference number 1 to 5 for a 6-party Conference, or 1 to 9 for a 10-party Conference). Confer-
ence numbers are allocated in calling order from the Conference leader.
3. Dialed Conference number of Station or C.O./Tie line party is released from CFT trunk and party hears re-
order tone.
4. The leader returns to CFT trunk.
Using the feature key of a Multiline Terminal
• To make a Conference Call
The 6-Party or 10-Party Conference feature key and a maximum of 5 or 9 line keys for participants must be as-
signed to the Multiline Terminal of the conference leader.
1. (Conference leader) Press the line key.
2. Dial the number of the first party (station or C.O./Tie line) to be added to the conference.