Filter
Top Products
ATTENDANT CONSOLE
SN610 ATTCON
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
Page 20
NDA-24271, Issue 1.0
ATTENDANT CONSOLE
SN610 ATTCON
General Description
The Attendant Console (SN610 ATTCON) operates on a switched-loop basis with a maximum of 6 Attendant
loops terminating at each console on the associated interface card. The Attendant uses these loops for answering,
originating, holding, extending, and re-entering calls. When Attendant loop release is used, the number of loops
is effectively increased to a maximum of 12 for each console. The following pages describe the features asso-
ciated with the Attendant Console.
An alternate Attendant Position is described under Multiline Terminal Attendant Position.
Station Application
Attendant Console (SN610 ATTCON).
Operating Procedure
Detailed operating procedures are provided in Attendant Console User’s Guide.
Service Conditions
1. Each Firmware Processor (FP) can support up to 8 Attendant Consoles (SN610 ATTCON/SN716
DESKCON). A maximum of 8 Attendant Consoles (SN610 ATTCON/SN716 DESKCON) can be support-
ed per system.
2. Each Attendant Console requires a 2-pair cable. This cable cannot be longer than 4000 feet (1200 meters).
SN716 DESKCON
General Description
The Attendant Console (SN716 DESKCON) operates on a switched-loop basis with a maximum of 6 Attendant
loops terminating at each console on the associated Interface card. The Attendant uses these loops for answering,
originating, holding, extending, and re-entering calls. When Attendant loop release is used, the number of loops
is effectively increased to a maximum of 12 for each console.
For the applicable features and specifications associated with the SN716 DESKCON, refer to the following pag-
es which describe the SN610 ATTCON features and specifications.
Station Application
Attendant Console (SN716 DESKCON).
Operating Procedure
The same operating procedures as the SN610 ATTCON are applied for each feature.