Filter
Top Products
DIAL BY NAME
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
NDA-24271, Issue 1.0
Page 131
To register a name and number for call by Speed Calling-Station
1. From the idle state, press the STA soft key.
2. Using the UP or DOWN soft keys, select the buffer number to be programmed.
3. Press the FEATURE key.
4. Using the Alphabet on keys 2 through 9, assign the name first. (Refer to Service Condition #2.)
5. Press the FEATURE key to program the number.
6. Dial the internal station number or the trunk access code (i.e., 9); then dial the outside number.
7. Press the FEATURE key. “SET” will appear on the display.
Service Conditions
1. Service
a. Up to 32 Multiline Terminals are available to use this feature at the same time.
b. The Multiline Terminal returns to idle status after the ten seconds from pressing SYS/STA key and no
key operation is activated.
c. If the speed calling memory block is not assigned to the Multiline Terminal, the SYS/STA key is not
affected when the Multiline Terminal user presses these keys.
d. This service feature is ended or interrupted by pressing the Hold key.
e. When the Multiline Terminal uses this feature, the incoming call to My Line is rejected.
f. When the Multiline Terminal uses this feature, the incoming call to Sub-Line key or trunk line
appearance can be terminated to the Multiline Terminal. In this case, the related line/trunk lamp is
flashed without ringing. The Multiline Terminal can answer the incoming call by pressing the
associated line/trunk key or Answer key.
g. When the Multiline Terminal uses this feature and the user dials the Line/Trunk/Answer key, this
feature is ended and Line/Trunk/Answer key is activated.
h. When the Multiline Terminal is in this service, pressing the Recall, Transfer, and Conf key are not
affected.
i. Up to eight Multiline Terminals can use the Help key at the same time.
j. The explanation displayed by the Help key will automatically be cleared unless the Exit key is
pressed for 16 to 20 seconds.