Filter
Top Products
MESSAGE REMINDER
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
NDA-24271, Issue 1.0
Page 217
To cancel a message from the station that set it
1. Lift the handset and receive dial tone.
2. Dial the Message Reminder cancel code.
3. Dial the desired station number and receive feature dial tone. The message is cleared at the dialed station.
4. Restore the handset.
Service Conditions
1. Single Line Telephones must be connected to a 4LCD/8LC card for this feature to operate. Single Line Tele-
phones must be equipped with message waiting lamps for 70 Vdc.
2. Multiline Terminals can be assigned a MSG key for use with this feature. This line button serves as an in-
dicator for received messages, and allows setting of Message Reminder to other stations (after dialing the
station number).
3. A maximum of four messages can be set to one station. If a fifth message is attempted, reorder tone is heard
and the LCD at the setting station shows:
RESTRICT
(when LCD is provided.)
4. A maximum of 200 messages can be set from stations in one system.
5. Message indications are battery backed up and are not lost due to power failure or initialization of the sys-
tem.
6. In Multiple Console Operation, messages set by one Attendant can not be canceled by another Attendant.
7. Messages can be set to a station in any status condition (idle, busy, in Line Lockout, etc.). Message indica-
tions are not provided when a Single Line Telephone handset is off-hook.
8. When a Multiline Terminal calls a station that is forwarded and then presses the MSG key, the message is
left at the station to which the call was forwarded.
9. When all stations in a hunt group are busy, messages set by a Multiline Terminal using the MSG key are
left at the called station.
10. Voice Mail Systems that provide in-band signaling for this purpose may be able to set Message Remind-
er(s).
11. Operating procedures and service conditions of a message waiting LED on Multiline Terminals without
LCD are the same as those of Single Line Telephones, except that the message waiting LED remains on
when the terminal is off hook.
12. To set Message Reminder service for Multiple Stations, set Message Reminder for the first station, wait for
feature dial tone, and then set the reminder for the next station.
13. The number of messages is displayed while the Multiline Terminal is in an idle state.
14. The number of messages displayed includes the setting of Message Waiting.