Filter
Top Products
DIAL BY NAME
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
NDA-24271, Issue 1.0
Page 133
3. Number and Name Registration
a. In the alphabet and number input mode, when the Feature key is pressed, the Feature key lamp is
flashed and Speaker key lamp is lit.
b. Up to 16 characters can be recorded as a name.
c. Up to four digits of trunk access code and up to 26 digits of station number can be recorded.
d. When the new name and number is recorded, the system automatically search the vacant memory
block after pressing Feature key.
e. In the name and number registration operation, if both name and number are not registered in speed
calling memory block, the Multiline Terminal LCD shows as follows.
4. Search
a. Up to four characters are used as a key word when the number is searched by name.
b. If the Multiline Terminal user enters character exceeding four, it is invalid.
c. When the same name has been registered in the system, the LCD shows the name and number which
are assigned the lowest memory block number.
d. When searching is performed without entering a key word, the LCD shows the lowest memory block
number available for the Multiline Terminal.
e. When no key word for searching has been registered, the LCD shows the lowest memory block
number available for the Multiline Terminal.
f. After searching, the Multiline Terminal user can search next speed calling number by pressing UP or
DOWN key.
UP= displays the lower number than the block number displayed.
DOWN= displays the higher number than the block number displayed.
When the block number reaches the lowest/highest by pressing UP or DOWN key, one more pressing
rounds to the highest/lowest memory block number.
g. When searching is performed, the first 24 digits are displayed if the number exceeds 24 digits
including memory block number.
h. When system utilize the Speed Calling-Station memory block 0, 1, 2, and 3 for Speed Calling-
System, another “SYS” Soft Keys should be assigned for each memory block basis.
• Speed Calling-System 300 memory : F5014 (standard)
• Speed Calling-System 1000 memory (Block No. 0): F5016
• Speed Calling-System 1000 memory (Block No. 1): F5017
• Speed Calling-System 1000 memory (Block No. 2): F5018
• Speed Calling-System 1000 memory (Block No. 3): F5019
When the Speed Calling-System memory is limited to use by CM08, searching of the Speed Calling-
System 1000 memory should not be done. (Pressing SYS key is ineffective.)
i. When Speed Calling Security is effective, the speed calling number is not displayed on Multiline
Terminal LCD but the name is displayed on Multiline Terminal LCD.
11:22 PM MON 12 MAR 1999
ABC UP DOWN
35: