Filter
Top Products
TRUNK-TO-TRUNK CONNECTION
NEAX2000 IVS
2
Business/Hotel/Data Features and Specifications
Page 314
NDA-24271, Issue 1.0
TRUNK-TO-TRUNK CONNECTION
General Description
This feature provides any station user with the ability to conference together two outside trunk calls and abandon
the connection without dropping the Trunk-to-Trunk Connection.
Station Application
All stations.
Operating Procedure
To establish a Trunk-to-Trunk Connection from a Single Line Telephone
1. Press the FLASH key (or momentarily press the hookswitch). The original call is placed on Consultation
Hold and feature dial tone is received.
2. Dial the applicable trunk access code.
3. Dial the desired number and wait for the party to answer.
4. Press the FLASH key (or momentarily press the hookswitch). A Conference is now in progress.
OR
Restore the handset. The original caller and the second party are now connected.
To establish a Trunk-to-Trunk Connection from a Multiline Terminal
1. Press the Transfer key. The original call is placed on Consultation Hold and feature dial tone is received.
2. Dial the applicable trunk access code.
3. Dial the desired number and wait for the party to answer.
4. Press the Conf key. A Conference is now in progress.
OR
Restore the handset. The original caller and second party are now connected.
To establish a Trunk-to-Trunk Connection from an Attendant Console
1. Attendant answers an incoming call.
2. Dial the applicable trunk access code. The original party is placed on Consultation Hold.
3. Dial the desired number.
4. Press the RLS key. The original caller and second party are now connected.
Service Conditions
1. The initiating station may hang up at any time. The additional two parties will not be disconnected.
2. At least one of the two trunks must provide a release signal (some loop start trunks do not provide any signal
after the distant party abandons the call).
3. This feature may be restricted to individual stations in system data programming.
4. If an originating Single Line Telephone encounters a busy or no answer condition after dialing out to Con-
ference a third party, the originating party can be reconnected to held caller by providing a hookflash or by
pressing the FLASH key to establish a Conference, and a second hookflash to release the last party called.