Filter
Top Products
Error and confirmation messages P (Pattern–Program)
1025
monaural multisample, select Single. If converting a
stereo multisample, select Double.
P (Pattern–Program)
Pattern conflicts with events
Meaning: It was not possible to execute the Bounce
operation because one of the tracks contained a
pattern, and the same measure of the other track
contained events or a pattern.
• Open the pattern.
Pattern exists across destination to-end-
of-measure or source from-measure
Meaning: When moving a measure, the edit operation
could not be executed because a pattern had been put
in the destination end measure or the source start
measure, and had not been opened.
• Open the pattern.
Pattern exists in destination or source
track - Open pattern?
Meaning: A pattern has been placed in the track that
you specified as a destination or source for editing. If
you wish to open the pattern and execute (the events of
the pattern will be copied), press the OK button. If you
wish to execute without opening the pattern, press the
Cancel button.
Pattern used in song - Continue ?
Meaning: When editing, the specified pattern has been
placed in a track. If you wish to execute, press the OK
button. If you decide not to execute, press the Cancel
button.
Program Bank Type conflicts
Meaning: When receiving a dump of an individual
bank or a single program, the OASYS received a
program that did not match the bank type. If the bank
type does not match, the program will not be received.
Meaning: When receiving an All Programs dump, the
OASYS received a bank whose bank type did not
match. Only banks of the matching bank type will be
received.
• If you’re receiving USER-A–G banks, set Global Set
Program User -Bank Type to the same bank type as
the transmitting source. Then try the operation
again.
Program Type conflicts
Meaning: This message will appear when you execute
Copy Tone Adjust if the copy-source and copy-
destination program types are different. You cannot
copy between HD-1 and EXi Programs, or between
different types of EXi Programs.
R (Rear sample–Root)
Rear sample is empty
Meaning: When you executed Link in the Sampling
mode Sample Edit page, the sample that you specified
as the rear sample is empty.
• Specify a sample that contains data as the rear
sample, and execute once again.
Root directory is full
Meaning: You attempted to create a file or directory in
the root directory of the media, but this would exceed
the maximum number of root directory entries.
• Either delete an existing file or directory, or Open a
directory to move down one level before executing
once again.
S (Sample–Source)
Sample data used in other sample(s)
Continue?
Meaning: Other sample(s) use the same sample data as
the sample that you are editing. To continue editing,
press the OK button.
Sample L and R are identical
Meaning: The edit operation could not be executed
because the destination (save location) L and R sample
numbers are identical.
• Select different sample numbers for L and R of the
destination (save location).
Sample length is shorter than minimum
Meaning: You attempted to execute an editing
operation that would make the sample data shorter
than 8 samples.
• Change the editing range so that the sample data
will be longer than 8 samples.