Filter
Top Products
Program P8: Insert Effect 8–1: Routing
125
8–1f: OSC MFX Send
OSC1 Send1 (to MFX1) [000…127]
Sets the volume (send level) at which the output of
oscillator 1 will be sent to master effect 1. This applies
only when Bus Select (8–1c) is set to L/R or Off.
If Bus Select is set to IFX1–IFX12, the send levels to
master effects 1 and 2 are set by Send 1 and Send 2 (8–
5a) after passing through IFX1–12.
OSC1 Send2 (to MFX2) [000…127]
Sets the volume (send level) at which the output of
oscillator 1 will be sent to master effect 2 (see “OSC1
Send1 (to MFX1)”).
OSC2 Send1 (to MFX1) [000…127]
OSC2 Send2 (to MFX2) [000…127]
Sets the volume (send level) at which the output of
OSC2 will be sent to master effects 1 and 2. These
parameters will be valid when Oscillator Mode is set
to Double and Bus Select is set to L/R or Off.
Note: You can use the control surface to control Send1
and Send2. These can also be controlled from the mixer
section of the front panel, or from the P0– Control
Surface page of the LCD screen. Here’s the procedure
for editing these settings from the front panel.
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to turn it on (lit).
2. Press the MIXER KNOBS switch to select
CHANNEL STRIP.
3. Use the MIXER SELECT 1–2 switches to select the
oscillator whose send levels you want to adjust.
4. Use FX SEND 1 (knob 7) and FX SEND 2 (knob 8)
to control the send levels.
If Bus Select (IFX/Indiv. Out Assign) is set to L/R or
OFF, this will control OSC1 Send1 (to MFX1) and
OSC2 Send2 (to MFX2).
If “Bus Select (IFX/Indiv. Out Assign) is set to
IFX1–12, this will control Send1 and Send2 (P8–
Insert FX page).
CC#93 controls OSC 1/2’s Send 1 level, and CC#91
controls the Send 2 level. These are controlled on the
global MIDI Channel (Global 1–1a). The actual
send level is determined by multiplying these
values with the send levels of each oscillator.
▼ 8–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy Insert Effect. For more information, see
“Copy Insert Effect” on page 149.
• 3: Swap Insert Effects. For more information, see
“Swap Insert Effect” on page 150.