Filter
Top Products
Combination mode
410
Copy Insert Effect
This command copies effects settings from Program,
Combination, Song, or Sampling modes. For more
information, please see “Copy Insert Effect” on
page 149.
Note: the slot’s MIDI control channel, as specified by
the Ch parameter on the IFX1–12 pages, will not be
copied.
Swap Insert Effect
This command swaps (exchanges) insert effect settings.
For more information, please see “Swap Insert Effect”
on page 150.
Note: the slot’s MIDI control channel, as specified by
the Ch parameter on the IFX1–12 pages, will not be
swapped.
Insert IFX Slot
For more information, please see “Insert IFX Slot” on
page 150.
Cut IFX Slot
For more information, please see “Cut IFX Slot” on
page 151.
Clean Up IFX Routings
For more information, please see “Clean Up IFX
Routings” on page 152.
Drum Kit IFX Patch
This patches the Bus Select settings for each key of a
drum kit, temporarily changing the insert effect
connection destinations. You can execute this only if
the timbre’s program is a drum program, “DKit” is
checked, and the Bus Select (Global 5–3b) setting of
the keys in the drum kit is set to either IFX1–12.
1. In the Routing1 page or Routing2 page, select the
timbre for which you want to make settings.
(Select a timbre parameter or Timbre Number.)
2. Select Drum Kit IFX Patch to open the dialog box.
3. In the DrumKit “IFX” popup, select the output bus
to which you want to patch the signal: an insert
effect or L/R, 1–8, 1/2–7/8, or Off.
4. To execute the Drum Kit Insert Effect Patch
command, press the OK button. To cancel, press
the Cancel button.
Note: To restore the condition of the drum kit, execute
IFX1→IFX1, IFX2→IFX2, IFX3→IFX3, IFX4→IFX4,
IFX5→IFX5, IFX6→IFX6, IFX7→IFX7, IFX8→IFX8,
IFX9→IFX9, IFX10→IFX10, IFX11→IFX11, and
IFX12→IFX12.
Alternatively, you can press the Reset button to restore
the same settings.
Copy MFX/TFX
This command copies effect settings from Program,
Combination, Song, or Sampling modes. For more
information, please see “Copy MFX/TFX” on
page 153.
Note: the slot’s MIDI control channel, as specified by
the Ch parameter on the MFX 1-2 and TFX 1-2 pages,
will not be copied.
Swap MFX/TFX
This command swaps (exchanges) insert effect settings.
For more information, please see “Swap MFX/TFX” on
page 154.
Note: the slot’s MIDI control channel, as specified by
the Ch parameter on the MFX 1-2 and TFX 1-2 pages,
will not be copied.
Write FX Preset
For more information, please see “Write FX Preset” on
page 154.
RESET