Filter
Top Products
Insert Effects (IFX1…IFX12) Routing
735
If Bus Select is set to IFX1–12, use Send1 and Send2
(Program 8–5a) to specify the send level of the post-IFX
signal.
Send1 responds to CC#93, and Send2 responds to
CC#91. At this time, the actual send level uses the
value of the Send 1 and 2 settings for Oscillators 1
and 2, multiplied by the Send 1 and 2 values
received via MIDI.
In the example shown in the diagram (Fig. 2–1a),
Oscillators 1 and 2 outputs being sent to IFX1.
If you are connecting the Insert Effects in series, check
the Chain box (Program 8–5a). Use Chain to (Program
8–5a) to specify the destination to which the signal will
be chained.
If you check the IFX1 checkbox, the output of IFX1 will
be sent to the input of the IFX you specify in “Chain
to.” Effects can be chained only in ascending order of
their number; for example IFX1 can be chained to IFX2
through IFX12, and IFX2 can be chained to IFX3
through IFX12. You can create a chain of up to twelve
insert effects in series, IFX1 through IFX12.
When the Insert Effects are connected in series, the
values of the Pan (CC#8), Bus Sel., REC Bus, Send1,
and Send2 parameters for the post-IFX signal will be
used.
In the example shown in the diagram (Fig. 2–1b), the
Chain check box is checked, and each Chain to
parameter is set to the subsequent effect, creating a
series connection of IFX1 → IFX2 → IFX3 → IFX4 →
IFX5 → IFX6 → IFX7 → IFX8 → IFX9 → IFX10 → IFX11
→ IFX12. The post-IFX12 settings for Pan (CC#8), Bus
Select, REC Bus, Send1, and Send2 will be used.
Settings for drum programs
If you have selected “Drums” for Oscillator Mode
(Program 1–1b) of a Program, the “Use DKit Setting”
box (Program 8–1b) becomes available. For more
information, please see diagram Fig. 2–1c.
If you check this box, Bus Select FX Control Bus,
Send1, and Send2
(Global 5–3b) for each key of the
selected DrumKit becomes effective. For example, you
can send a snare sound to IFX1 to apply the Gate effect,
a kick sound to IFX2 to apply EQ, and other sounds to
AUDIO OUTPUT (MAIN) L/MONO and R without
applying any Insert Effects.
Tip: In most of the preloaded drum kits, the following
types of drum instrument have the same Bus Select
settings.
Snares → IFX1
Kicks → IFX2
Toms → IFX3
Cymbals → IFX4
Percussion etc. → IFX5
If you de-select the box, all drum instrument outputs
are sent to the bus specified by Bus Select (Program 8–
1c). You may apply any Insert Effects to all drum
instruments, regardless of the DrumKit settings.
Fig. 2–1a