Filter
Top Products
Global mode
658
1–3: External 2
This page lets you set up the drum pad assignments
for the Control Surface’s EXTERNAL mode. Each pad
can play a note, or send a Control Change (CC)
message, on any of the MIDI channels. For more
information, see “1–2: External 1” on page 656.
1–3a: Setup select
Setup [000…127]
This selects the Global setup to edit.
1–3b: Pads 1–8
MIDI Channel (1–8) [1…16, Gch]
This sets the MIDI Channel for the pad. Each can send
on a different channel, if desired.
Gch means that the pad will transmit on the Global
MIDI Channel, as set in Global mode. This allows you
to re-direct any number of sliders, knobs, switches, and
pads to a different channel at once, without editing the
individual controls.
Assign (1–8) [Off, C-1…G9, CC#00…119]
Each pad can send either a MIDI note or a MIDI CC
message. When assigned to a CC, the pad sends a
value of 127 when it is pressed down, and a value of 0
when it is released.
Velocity (1–8) [1…127]
The front-panel PAD MODE button switches the pads
between being velocity sensitive (so that the loudness
varies depending on how hard you hit the pad) and
playing a single, fixed velocity for each note (handy if
you want the same results every time, regardless of
how hard you play).
This lets you set the pad’s fixed velocity.
▼ 1–3: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Global Setting. For more information, see
“Write Global Setting” on page 682.
• 1: Dump Program. For more information, see
“Dump Program” on page 685.
• 2: Dump Combination. For more information, see
“Dump Combination” on page 685.
• 3: Dump Drum Kit. For more information, see
“Dump Drum Kit” on page 685.
• 4: Dump Wave Sequence. For more information,
see “Dump Wave Sequence” on page 685.
• 5: Dump Global Setting. For more information, see
“Dump Global Setting” on page 685.
• 6: Dump Sequencer. For more information, see
“Dump Sequencer” on page 685.
• 7: Setup KARMA External MIDI Routing. For
more information, see “Set Up KARMA External
MIDI Routing” on page 686.
• 8: Reset External Setup. For more information, see
“Reset External Setup” on page 687.
1–3a
1–3b
1–3PMC