Filter
Top Products
Sequencer P7: KARMA 7–3: Module Parameters-Control
501
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 8: Set Location (for Locate Key). For more
information, see “Set Location (for Locate Key)” on
page 525.
• 9: Copy From Program. For more information, see
“Copy From Program” on page 526.
7–3: Module Parameters-Control
Here you can set KARMA Module Control parameters.
In Sequencer mode, four KARMA Modules ([A], [B],
[C], [D]) can be used.
7–3a: Module Parameter-Control
Control
Transpose [–36…+36]
Force Range
[Off, Lowest, Highest, C3–B3[1], C3–B3[2]]
Force Range Wrap [C#…C]
Timbre Zone Bypass [Off, On]
Root Position [Off, On]
For more information, see “Control” on page 103 and
p.380.
Clock Advance
Mode [Auto, Dyn, Auto+Dyn1, Auto+Dyn2]
Size [3, 3, , 3, , ., 3, , ., 3, , Event]
Chord Trigger Mode [Off, 1st, Chord1, Chord2,
Chord3]
Velocity Sense Bottom [001…127]
Please see “Clock Advance” on page 105..
Note Map
Mode (Note Map Mode)
[Off, On-Main, On-Rpt, On-All]
Table (Note Map Table)
[Custom, Gtable 1…Gtable 64]
Transpose (Note Map Transpose) [–12…+12]
Chord Track (Note Map Chord Track) [Off, On]
Keyboard Track (C2 Ref)
1–1a
7–3a
7–3PMC