Filter
Top Products
Disk mode
708
• If you check “Load ********.KSC too,” use “Select
.KSC Allocation” to specify how the multisamples
and samples within the .KSC file will be loaded.
See “1) Load .PCG: 4.”
3. Press the OK button to load the data, or press the
Cancel button to cancel without loading.
Load a Song
Data for the selected song will be loaded into the song
number you specified as the load destination.
1. If you wish to load a song other than the selected
song, use Song (upper line) to re-select the song to
be loaded.
2. In “To Song” (lower line), select the loading
destination song.
3. If you’ve selected “with Region Data” On
(checked), the region data used in the song being
loaded will also be loaded following the last
region number existing in internal memory, with
data packed into each consecutive location
(Append load).
At this time, the region numbers of the song will be
reassigned so that they correspond correctly to the
region data.
4. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Tracks
The event data of all tracks in the selected song will be
loaded into the song you specify as the loading
destination. However, it is not possible to specify an
uncreated song as the loading destination.
1. In Song, specify the loading destination song.
2. If you’ve selected “with Region Data” On
(checked), the region data used by the song tracks
being loaded will also be loaded following the last
region number existing in internal memory, with
data packed into each consecutive location
(Append load).
At this time, the region numbers of the tracks in the
song will be reassigned so that they correspond
correctly to the region data.
3. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Pattern Data
The selected user pattern will be loaded into a user
pattern of the selected loading destination song.
However, it is not possible to specify an uncreated
song as the loading destination.
1. If you wish to load a user pattern other than the
one already selected, use Pattern (upper line) to re-
select the user pattern that you wish to load.
2. In “To Song” and Pattern (lower line), select the
loading destination song and user pattern.
3. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Regions
All region data will be loaded from the .SNG file.
1. Use “Select Regions Allocation” to specify how
the song data in the .SNG file will be loaded.
Append: The data will be packed into each
consecutive location following the last region
number existing in internal memory. Choose this
method when you want to load additional region
data from the disk without erasing the region data
already in internal memory.
Clear: All region data in internal memory will be
erased, and the region data will be loaded in the
configuration that existed when it was saved.
Choose this method when you want to replicate the
configuration that you saved, such as immediately
after turning the power on.
If you load using Append, the region numbers used
by the song may no longer correspond correctly. If
so, you will need to re-select the region numbers
used by the song. When loading song data, you will
normally use Load .SNG or Load a Song and check
the “with Region Data” setting. Even if you load
using Append, the region numbers of the song will
automatically be re-specified so that the song will
correspond to the correct region data.
2. To load the data, press the OK button. To cancel
without loading, press the Cancel button.