Filter
Top Products
Effect Guide
762
Multiband Limiter
The Multiband Limiter is used in 006: Multiband
Limiter and 007: Stereo Multiband Limiter.
008: Stereo Master Limiter
Dyna Compressor
Dyna Compressor is used in 001: Stereo Dyna
Compressor, and in “Comp” of Mono-Mono Serial and
Mono//Mono Parallel effects #114 and following.
010: Stereo Noise Reduction
Indicates the output response
relative to the input. This will
change according to the Ratio and
Threshold settings. (This is the
same as the Stereo Limiter.)
Threshold level indication.
This is a realtime indication of the
control input signal level (Input) for
each band. The level will change
according to the Offset setting.
This is a realtime indication of the
gain reduction relative to the
control input signal of each band.
Indicates the output response relative to the input. This will change according
to the Threshold setting.
The Mastering Limiter applies limiting at the Threshold level, and optimizes the
output level as high as possible.
For each channel L and R, this is a realtime indication of the control
input signal level (Input), the gain reduction produced by the control
input signal (Gain Reduce), and the output signal level (Output).
Stereo Dyna Compressor dynamically controls the input/output
response according to the Sensitivity setting so that the output level
will rise as the input signal level decreases.
This is a realtime indication of the control input signal level (Input),
the gain reduction produced by the control input signal (Gain
Reduce), and the output signal level (Output).
Noise Reduction reduces the noise level below the Threshold.