Filter
Top Products
Program P4: String 4-9: Mixer
259
4-9: Mixer
The Mixer page controls the volume levels and filter
routing for the main String output, as well as the direct
outputs (bypassing the string) of the PCM oscillator
and Noise Generator. For instance, you can:
• Control the volume levels for the String, the PCM
Oscillator, and the Noise Generator.
• Modulate these volume levels via AMS.
• When the Filter Routing is set to either Serial or
Parallel, you can route each of the five elements
through Filter A, Filter B, or a combination of the
two–and then modulate that routing via AMS. For
instance, you can create a layer by setting the Filter
Routing to Parallel, and then sending the PCM
Oscillator to Filter A, and the String to Filter B.
4-9a: String
Level [0…100]
This controls the volume level for the String.
AMS [List of AMS Sources]
This selects an AMS source to control the String Level.
For a list of AMS sources, see “AMS (Alternate
Modulation Source) List” on page 967.
Intensity [-100…+100]
This controls the depth and direction of the String
Level AMS modulation.
Balance [0…100]
This controls the filter routing for the String. It applies
only when the Filter Routing is set to either Serial or
Parallel; otherwise, it is grayed out.
0 is the default, and means that the String goes into
Filter A. If the Filter Routing is set to Serial, it will also
pass through Filter B.
99 means that the String goes into Filter B.
In between, the String will go to a combination of both
filters. By modulating the Balance via AMS, you can
crossfade between routing through Filter A and Filter
B. For more information, see “Interaction between the
filters and the mixer,” on page 261.
AMS [List of AMS Sources]
This selects an AMS source to control the String
Balance. For a list of AMS sources, see “AMS
(Alternate Modulation Source) List” on page 967.
Intensity [-100…+100]
This controls the depth and direction of the String
Balance AMS modulation.
Phase Invert [Off, On]
This inverts the phase of the String.
4-9b: PCM Oscillator
This controls the volume level and balance for the
PCM Oscillator. It has the same parameters as
described under “4-9a: String,” above.
4-9c: Noise
The Noise Generator has the same mixer parameters as
described under “4-9a: String,” above.
4–9a
4–9b
4–9c
4–9d
4–9e
4–9PMC