Filter
Top Products
Program P0: Play 0–8: Audio Input/Sampling
17
and reduce it to the minimum size necessary. For more
information, see “Truncate (for Sample Edit)” on
page 623 and “Truncate (for Loop Edit)” on page 628.
You can also press the SAMPLING START/STOP
switch to manually stop sampling after you have
recorded the desired material. For more details on
sampling, see “Preparations for sampling” on page 121
of the Operation Guide.
If Save to is set to RAM, and you continue sampling
with the Auto Optimize RAM (Global 0–1d) option
unchecked, wasted space will develop in memory,
decreasing the amount of available RAM. In this
case, use the Optimize RAM menu command to
recover the wasted space.
Note: “Free Sample Memory/Locations” (Sampling 0–
1f) in Sampling mode lets you check the remaining
amount of RAM.
Note: The various Recording Setup settings are not
made independently for each program; they apply to
the entire Program mode.
0–8d: Metronome Setup
Here you can specify the output destination and
volume of the metronome, as set up in by “Metronome
Precount” (0–2c). The metronome is available only if
“Trigger” is set to Sampling START SW.
Bus (Output) Select [L/R, L, R, 1…8]
This sets the audio output for the metronome sound.
L/R: The metronome will be hear d in the main stereo
outputs (L/Mono and R), the S/P DIF output, and the
headphones.
1…8: The metronome will be heard only in the selected
individual output.
Level [000…127]
This controls the volume of the metronome sound.
▼ 0–8: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Optimize RAM. For more information, see
“Optimize RAM” on page 139.
• 3: Select Sample No. This applies only when Save
to is set to RAM. For more information, see “Select
Sample No.” on page 139.
• 3: Select Directory. This applies only when Save to
is set to Disk. For more information, see “Select
Directory” on page 140.
• 4: Auto Sampling Setup. For more information, see
“Auto Sampling Setup” on page 141.