Filter
Top Products
Combination P8: Insert Effect 8–7: IFX 1–12
399
• 4: Insert IFX Slot. For more information, see “Insert
IFX Slot” on page 150.
• 5: Cut IFX Slot. For more information, see “Cut IFX
Slot” on page 151.
• 6: Clean Up IFX Routings. For more information,
see “Clean Up IFX Routings” on page 152.
8–7: IFX 1–12
This page lets you edit the detailed parameters of the
twelve insert effect s. Use the tabs at left to select IFX1
through IFX12.
To select different effects types, use the Insert FX or
Track View pages. For more information, see “8–5:
Insert FX” on page 396 and “8–6: Track View” on
page 398.
Effects Modulation: Dmod
Most effects have one or more parameters which can
be modulated in realtime. In the OASYS, this is called
Dynamic Modulation, or Dmod for short.
For a complete list of Dmod sources, see “Dynamic
Modulation Source List” on page 976.
You can use different MIDI channels to control
Dmod for each effect, if desired, as selected by the
Ch (Control Channel) parameter.
8–7a: IFX1
IFX1 On/Off [Off, On]
Turns the insert effect on/off. This is linked with the
on/off setting in the P8– Insert FX page.
Ch (Control Channel) [Ch01…16, G ch, All Routed]
This parameter specifies the MIDI channel that will be
used to control effect dynamic modulation (Dmod),
pan following the insert effect (CC#8), Send 1, and
Send 2.
The channel number of the timbre routed through this
IFX will be followed by a “*” displayed at the right of
Ch01–16. If two or timbres with different MIDI channel
settings are routed through the same IFX, this
parameter specifies which of these channels will be
used to control the effect.
G ch: The global MIDI Channel (Global 1–1a) will be
used to control the effect. Normally you will set this to
G ch.
All Routed: The channel of any timbre routed through
this effect can be used to control the effect. (Channels
of each routed timbre will be indicated by “*”.)
Drum Kits and the MIDI Control Channel
If a Timbre is using a Drum Kit, and the Timbre’s Bus
Select (IFX/Indiv. Out Assign) DKit (8–1b) is enabled,
this effects the MIDI Control Channel as well. In this
case, the Timbre’s MIDI channel will be used to control
any effect whose Ch is set to All Routed, regardless of
the Bus Select (Global 5–3b) settings or the settings of
the DrumKit IFX Patch page menu command.
8–7PMC
8–7a
8–7b