Filter
Top Products
EXi: PolysixEX
316
Program P5: Modulation & Arpeggiator
5-1: Modulation & Arpeggiator
5-1a: EXTERNAL MODULATION
The External Modulation section offers an easy way to
assign modulation to multiple destinations at once,
using any AMS source. Note that most parameters also
include dedicated AMS modulation, via the Parameter
Details area.
Source 1
SOURCE 1 [List of AMS Sources]
This selects the modulation source to control the
parameters below. For a list of AMS sources, see “AMS
(Alternate Modulation Source) List” on page 967.
VCO PULSE WIDTH [–10.00…+10.00]
Specifies the depth and direction of the modulation
applied to the oscillator (VCO) PW/PWM.
VCF CUTOFF [–10.00…+10.00]
Specifies the depth and direction of the modulation
applied to the filter (VCF) CUTOFF.
VCA GAIN [–10.00…+10.00]
Specifies the depth and direction of the modulation
applied to the amp (VCA).
MG LEVEL [–10.00…+10.00]
Specifies the depth and direction of the modulation
applied to the MG (Modulation Generator) LEVEL.
Source 2
This allows you to route a second AMS source to the
same list of mod destinations. The parameters are
identical to those under “Source 1,” above.
5-1b: ARPEGGIATOR
ON/OFF [Off, On]
Switches the arpeggiator on/off.
KEY SYNC [Off, On]
If this setting is ON, the arpeggiator will be reset at the
beginning of each legato phrase.
This parameter is not modulatable.
TEMPO SYNC [Off, On]
Touch the text/LED area to turn TEMPO SYNC on
and off.
On (LED lit): When TEMPO SYNC is On, the
arpeggiator synchronizes to the system tempo, as set
by either the Tempo knob or MIDI Clock. The
arpeggiator speed is controlled by the combination of
the BASE NOTE and SPEED/TIMES parameters,
below.
Off (LED dark): When TEMPO SYNC is Off, the
FREQUENCY/TIMES knob determines the speed of
the arpeggiator, and the BASE NOTE setting has no
effect.
This parameter is not modulatable via AMS.
5–1a
5–1PMC
5–1c
5–1b
5–1d