Filter
Top Products
Combination mode
346
Combination P1: EQ/Vector/Controller
1–1: Timbre EQ
Each Timbre has a dedicated three-band EQ, with
sweepable mid band. This page lets you view and
adjust the settings for all 16 Timbres at once.
Timbre EQ and the control surface
You can use the Control Surface to adjust almost all of
the Timbre EQ parameters (except for Bypass). To do
so:
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to select either timbres 1–
8 or 9–16.
2. Use the MIX SELECT 1/9–8/16 switches to select
the timbre you want to control.
3. Press the MIXER KNOBS switch to select
CHANNEL STRIP.
4. Use the MIX CHANNEL STRIP knobs 2-6 to
adjust the EQ TRIM, LOW EQ gain, MID EQ
frequency and gain, and HIGH EQ gain, as
desired.
1–1a: Combination Name
Bank [INT–A…INT–G, USER–A…USER–G]
Combination Name [(000…127: Name)]
These display-only parameters show the bank,
number, and name of the current Combination.
(Tempo) [040.00…240.00, EXT]
This is the tempo for the current Combination, which
applies to tempo-synced LFOs and Wave Sequences,
the Vector EG, EXi Step Sequencers, KARMA, and
tempo-synced effects.
EXT means that the tempo will sync to external MIDI
clocks. For more information, see “Tempo” on
page 323.
040.00…240.00 allow you to set a specific tempo in
BPM, with 1/100 BPM accuracy.
1–1b: 3 Band Parametric EQ
Selected Timbre Info
This area displays information about the timbre
selected for editing – T: timbre number/program
bank/number/name, Ch: MIDI channel number.
Timbre Number
This indicates the timbre number. The various
parameters below each timbre number make settings
for the corresponding timbre.
Timbre Category
This shows the abbreviated category name of the
Program assigned to the Timbre.
1–1a
1–1b
1–1PMC
Select Timbre Info
Timbre Number
Timbre Category