Filter
Top Products
Program mode: HD-1
22
0–9c: Audio Inputs
This Control Assign setting lets you adjust the volume,
pan, and FX send settings for each of the six audio
inputs: Analog 1–4, and S/P DIF left and right.
You can use this page to mix sounds from other
sources into the OASYS outputs - as an on-stage
submixer, for instance.
Other Audio Input settings
Each audio input can be assigned to up to three busses:
• An Output/IFX Bus
• An FX Control Bus
• A REC Bus
You can set up these bus assignments on the Audio
In/Sampling page. For more information, see “0–8:
Audio Input/Sampling” on page 11.
Use/Edit Global Setup [Off, On]
Programs can use the single, Global audio input mixer
setup, or can instead have their own custom settings.
When Use/Edit Global Setup is On, the Program uses
the Global settings. This is the default, and lets you
change freely between different Programs and
Combinations without affecting the audio inputs.
Also, any edits made on this page will affect the Global
setting, along with any other Programs, Combis, or
Songs which use the Global setting.
On the other hand, it may sometimes be convenient to
save a particular mixer setup with an individual
Program, to set up special sub-mixer settings or effects
processing for particular inputs. In this case, set
Use/Edit Global Setup to Off, and the audio inputs
will use the Program’s custom settings.
Mixer Knobs [Channel Strip, Individual Pan]
This switch controls whether the knobs show the pan
settings for all 6 inputs at once (Individual Pan), or the
pan and FX Send levels for the selected input (Channel
Strip). For more information, please see “Mixer Knobs”
on page 22.
Knobs 1–8, Channel Strip
When the Mixer Knobs switch is set to Channel Strip,
the knobs provide quick access to the selected input’s
Pan and FX Send parameters.
Pan [L000…C064…R127]
This controls the stereo pan of the selected input. A
setting of L000 places the sound at the far left, C064 in
the center, and R127 to the far right.
Send 1 [000…127]
This controls the send level into FX Send 1. If the
input’s Output Bus parameter is set to L/R or OFF, it
scales the programmed send level. If the Output Bus is
set to IFX 1–12, it directly controls the post-IFX send
levels, overwriting any previous setting.
Send 2 [000…127]
This controls the send level into FX Send 2. For more
details, see “Send 1,” above.
Knobs 1–6, Individual Pan
When the Mixer Knobs switch is set to Individual Pan,
knobs 1–4 control the pan settings for analog inputs 1–
4, respectively, and knobs 5–6 control the pan settings
for the left and right S/P DIF inputs. Knobs 7 and 8
have no effect.
0–9c