Filter
Top Products
Appendices
1040
Installing the calendar battery
1. Open the front panel as described in steps 1–6 of
“Opening and closing the front panel,” on
page 1037.
2. Remove the two screws from the memory/calendar
battery cover.
3. Raise the cover to the angle shown in the
following illustration; then pull out and remove it.
Be careful not to drop the cover or screws inside the
OASYS.
4. Remove the calendar battery that has run down.
Press the tab of the battery holder outward; the
battery will lift up.
Remove the battery from the battery holder.
Be careful not to drop the battery into the interior of
the OASYS.
5. Install the new battery.
With the “+” side of the calendar battery facing
upward, insert it into the battery holder at an angle,
and press it into place.
6. Close the memory/calendar battery cover.
Insert the lip at the front of the cover into the
groove, and align the screw holes. Use the two
screws to fasten the cover in place.
7. Close the front panel as described in “Opening
and closing the front panel,” steps 8 and 9.
8. When you’ve finished all of the steps, turn on the
power.
In this state, the calendar has not yet been set to the
correct date and time, so the following message will
appear.
The clock battery voltage is low. Please replace the battery,
and set the date and time in Disk mode.
9. Use the Disk mode page menu command “Set
Date/Time” to specify the correct date and time.
Press the MODE DISK switch to enter Disk mode. In
the LCD screen, press the File tab and then the
Utility tab to access the Disk Utility page.
From the page menu in the upper right of the LCD
screen, choose “Set Date Time.” A dialog box will
appear.
Choose “Year,” and press the switch.
Alternatively, use the numeric keys to enter the year
and press the ENTER switch.
You must specify a “Year” other than 2003. If this is
left at 2003, the above message will always appear
at power-on.
Then set the “Month,” “Day,” “Hour,” and
“Minute.”
Press the OK button to finalize the settings.
10.This completes the settings, but in order to verify
that the calendar battery is installed correctly, turn
off the power, wait approximately ten seconds,
and then turn the power on again. Verify that the
above message does not appear.
Memory/calendar
battery cover
Press
Tab