Filter
Top Products
Combination P7: KARMA 7–5: GE Real-Time Parameters
383
7–5: GE Real-Time Parameters
Here you can edit the Real-Time Parameters of the GE
for each KARMA Module [A]–[D]. In addition, you can
assign GE Real-Time Parameters to the KARMA Real-
Time Controls so that you can control the phrase or
pattern in real-time while you play.
7–5a: GE Number & Name, RTC Select,
and Tempo
GE Number & Name
[0000: Arp Model 01 Up/Dn…
2047: Tempo Env Repeats]
This shows the GE selected for the Module. For more
information, please see “0–6b: GE Select” on page 8.
GE RTC Select [1–16, 17–32]
This switches the GE realtime parameter display.
1–16: GE parameters 1–16 will be displayed.
17–32: GE parameters 17–32 will be displayed.
(Tempo) [040.00…240.00, EXT]
For more information, please see “Tempo” on page 5.
7–5b: GE Real-Time Parameters for
Module Control = Master
Module Control = Master lets you use a single
controller (e.g., Slider 1) to control multiple KARMA
Modules simultaneously, or control individual
parameters from different Modules conveniently at the
same time.
GE Real-Time Parameters 01…32
Here you can edit GE parameters and assign GE
parameters to KARMA Real-Time Controls etc. for use
with Module Control = Master.
GE PARAMETER (GE Real-Time Parameter)
MIN (Minimum Value) [–5000…+5000]
MAX (Maximum Value) [–5000…+5000]
VALUE [–5000…+5000]
ASSIGN [---, Slider1…8, Slider (SW)1…8,
SW1…8, DynaMIDI1…8]
POLARITY [+, –]
Please see “7–5b: GE Real-Time Parameters” on
page 110.
Note: Normally, the MIN, MAX, VALUE, and
POLARITY parameters of each module are specified
in module A, B, C, and D. These parameter settings are
possible if you specify ASSIGN in Master A, B, C, and
D.
For example if you want to use Slider1 to control the
GE REALTIME PARAMETER No.1 of modules A, B, C,
and D when Module Control is set to Master, you
would set the Master, A, B, C, and D’s GE REALTIME
PARAMETER No.01 ASSIGN to Slider1. If these are
set to ASSIGN, you are able to edit the MIN, MAX,
VALUE, and POLARITY parameters for Master, A, B,
C, and D.
In this way, you can make GE realtime parameter
settings independently of modules A, B, C, and D.
7–5a
7–5b
7–5c
7–5PMC