Filter
Top Products
EXi: CX-3 Tonewheel Organ
224
This parameter controls the difference in drawbar
volume between the Soft and Loud Percussion
settings.
6–1c: Decay
Decay [Slow, Fast]
This toggles the Percussion Decay time between Slow
and Fast. The actual decay times are determined by the
Fast Decay Time and Slow Decay Time parameters,
below.
AMS [List of AMS Sources]
This selects an AMS source to switch the Percussion
Decay time between Slow and Fast. For a list of AMS
sources, see “AMS (Alternate Modulation Source) List”
on page 967.
AMS Mode [Toggle, Momentary]
This determines the behavior of the Decay AMS. For
details, see “AMS Mode” on page 218.
Fast Decay Time [00…99]
This sets the decay time when the Decay parameter is
set to Fast.
Slow Decay Time [00…99]
This sets the decay time when the Decay parameter is
set to Slow.
6–1d: Harmonic
Harmonic [2nd, 3rd]
This selects the pitch of the percussion, in harmonics
relative to the 8’ drawbar.
2nd produces the same pitch as the 4’ drawbar - one
octave higher than the 8’.
3rd produces the same pitch as the 2 2/3’ drawbar -
one octave and a fifth higher than the 8’.
AMS [List of AMS Sources]
This selects an AMS source to switch the Harmonic
between 2nd and 3rd. For a list of AMS sources, see
“AMS (Alternate Modulation Source) List” on
page 967.
AMS Mode [Toggle, Momentary]
This determines the behavior of the Harmonic AMS.
For details, see “AMS Mode” on page 218.
▼ 6–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
6–2: EX Percussion
When the Drawbar Mode is set to EX, the Percussion
can use a mix of up to five drawbar pitches, instead of
just one.
These include 2-2/3’ or 4’ (depending on the setting of
the Percussion Harmonic parameter), 16’, 5-1/3’, and
the pitches of the first two EX drawbars. You can set
the levels for each of the five drawbars independently.
6–2PMC
6–2a