Filter
Top Products
Sequencer P2: Track Parameters 2–1: MIDI
467
MIDI Channel [01…16]
Specifies the MIDI channel that the MIDI track will use
to transmit and receive musical data. The MIDI
channel you specify here will be the receive channel
when Status is INT, the transmit channel when it is
EXT or EX2, and the receive/transmit channel when it
is BTH. Tracks set to INT which have the same MIDI
channel will sound and be controlled identically when
they receive MIDI data or data from the sequencer
tracks.
Bank Select MSB (When Status=EX2) [000…127]
Bank Select LSB (When Status=EX2) [000…127]
When Status is set to EX2, this sets the bank number
that will be transmitted. When Status is other than
EX2, this setting has no effect.
Track Priority [Off, On]
This specifies the voice priority for the MIDI track.
On (checked): MIDI tracks for which this is checked
will be given priority. If a new note-on would exceed
the available number of voices, a currently-sounding
voice will normally be stopped (“stolen”), allowing the
newly requested voice to be sounded. At this time,
MIDI tracks whose “Track Priority” is checked are less
likely to have a voice “stolen.”
However, this setting will have little meaning if it is
turned on for most or all tracks. It’s a good idea to
leave this unchecked for all tracks, and check it only
for important tracks that would cause a conspicuous
problem if notes were to drop out during the
performance.
Track 02…16 (Track Number)
These are the MIDI-related settings for MIDI tracks 2
through 16. They are the same as for track 1. See “Track
01”:.
▼ 2–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Rename Song. For more information, see
“Rename Song” on page 524.
• 3: Delete Song. For more information, see “Delete
Song” on page 524.
• 4: Copy From Song. For more information, see
“Copy From Song” on page 524.
• 5: Load Template Song. For more information, see
“Load Template Song” on page 524.
• 6: Save Template Song. For more information, see
“Save Template Song” on page 525.
• 7: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525
• 8: Set Location (for Locate Key.) For more
information, see “Set Location (for Locate Key)” on
page 525.
• 9: GM Initialize. For more information, see “GM
Initialize” on page 526.
• 10: Copy From Combination. For more
information, see “Copy from Combination” on
page 526.
• 11: Copy From Program. For more information, see
“Copy From Program” on page 526.
EX2 No
Yes (using the Bank
Select message
specified on the MIDI
tab of the Track
Param page)
BTH Yes Yes